BSUMSUBNETS-MIB
File:
BSUMSUBNETS-MIB.mib (3114 bytes)
Imported modules
Imported symbols
Defined Types
| AniBsuSubnetConfEntry |
|
| SEQUENCE |
|
|
|
| |
aniBsuSubnetConfAddr |
IpAddress |
|
| |
aniBsuSubnetConfMask |
IpAddress |
|
Defined Values
| aniBsuMultSubnets |
1.3.6.1.4.1.4325.3.6 |
| This group gives the BSU Multiple Subnets information.
The aniBsuSubnetConfTable is used to view and configure
subnets per wireless port.
There can be upto 1024 pairs.
For a given WSS port, there can be multiple and different
subnets. This means that each subnet specified by an
has to be distinct.
Atleast one Ip Address and Subnet Mask has to be specified.
In addition to the subnet being distinct, each IP Address
must be unique too.
If clustering is disabled, then Multiple Subnets on one
WSS port should not clash with Multiple Subnets on any
other WSS port.
Clustering and multiple subnets can exists simultaneously
as long as they are not on the same WSS. If clustering is
enabled but not all WSS are clustered, then those that are
not part of the cluster can have multiple subnets.
Eg. If WSS1 and WSS2 are clustered, but WSS3 and WSS4 are
not, then WSS3 and WSS4 can have multiple subnets.
To add a new subnet to the table, first set the
aniBsuSubnetConfAddr. Next send an SNMP set request
on aniBsuSubnetConfMask.
Currently, deletion and modification of entries is not supported.
When the BSU is in Bridge mode, this multiple subnets table is
not valid and will not be displayed.
|
| MODULE-IDENTITY |
|
|
|
| aniBsuSubnetConfEntry |
1.3.6.1.4.1.4325.3.6.1.1 |
| An entry in the aniBsuSubnetConfTable.
|
| Status: current |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
AniBsuSubnetConfEntry |
|
|
| aniBsuSubnetConfAddr |
1.3.6.1.4.1.4325.3.6.1.1.1 |
| The IP Address of the configured Subnet.
|
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
IpAddress |
|
|