CENTRECOM-TRAP-MIB
File:
CENTRECOM-TRAP-MIB.mib (3346 bytes)
Imported modules
Imported symbols
Defined Values
overheat |
6 |
A overheat trap indicates that the on board
tempature sensor has reported a overheat
condition. System will shutdown until unit has
sufficiently cooled such that operation may begin
again. A cold start trap will be issued when
the unit has come back on line. |
TRAP-TYPE |
|
|
|
fanfailed |
7 |
A fan failed trap indicates one or more of the
cooling fans inside the device has failed. A
fanOK trap will be sent once the fan has attained
normal operation. |
TRAP-TYPE |
|
|
|
fanOK |
8 |
A fan has transitioned out of a failure state and
is now operating correctly. |
TRAP-TYPE |
|
|
|
invalidLoginAttempt |
9 |
A user attempted to login to console or by telnet but was refused
access due to incorrect username or password |
TRAP-TYPE |
|
|
|
powerSupplyFail |
10 |
One or more sources of power to this agent has failed.
Presumably a redundant power-supply has taken over. |
TRAP-TYPE |
|
|
|
powerSupplyGood |
11 |
One or more previously bad sources of power to this agent
has come back to life without causing an agent restart. |
TRAP-TYPE |
|
|
|
rpsAlarm |
12 |
Attached Redundant Power Supply device is indicating
an alarm condition. |
TRAP-TYPE |
|
|
|
rpsNoAlarm |
13 |
Attached Redundant Power Supply device is no longer
indicating an alarm condition. |
TRAP-TYPE |
|
|
|