Wellfleet-WFDOT1D-MIB
File:
Wellfleet-WFDOT1D-MIB.mib (7576 bytes)
Imported modules
Imported symbols
Defined Types
| WfDot1dStaticTableEntry |
|
| SEQUENCE |
|
|
|
| |
wfDot1dStaticAddress |
OCTET STRING |
|
| |
wfDot1dStaticReceivePort |
INTEGER |
|
| |
wfDot1dStaticAllowedToGoTo |
OCTET STRING |
|
| |
wfDot1dStaticStatus |
INTEGER |
|
Defined Values
| wfDot1d |
1.3.6.1.4.1.18.3.5.1.1.6 |
| OBJECT IDENTIFIER |
|
|
|
| wfDot1dBaseBridgeAddress |
1.3.6.1.4.1.18.3.5.1.1.6.1.1 |
| The MAC address used by this bridge when it must
be referred to in a unique fashion. It is
recommended that this be the numerically smallest
MAC address of all ports that belong to this
bridge. However it is only required to be unique.
When concatenated with dot1dStpPriority a unique
BridgeIdentifier is formed which is used in the
Spanning Tree Protocol. |
| Status: mandatory |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
OCTET STRING |
|
|
| wfDot1dBaseNumPorts |
1.3.6.1.4.1.18.3.5.1.1.6.1.2 |
| The number of ports controlled by this bridging
entity. |
| Status: mandatory |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
|
|
| wfDot1dBaseType |
1.3.6.1.4.1.18.3.5.1.1.6.1.3 |
| Indicates what type of bridging this bridge can
perform. If a bridge is actually performing a
certain type of bridging this will be indicated by
entries in the port table for the given type. |
| Status: mandatory |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
unk(1), only(2), sr(3), srt(4) |
|
| wfDot1dStaticTable |
1.3.6.1.4.1.18.3.5.1.1.6.5.1 |
| 'A table containing filtering information
configured into the bridge by (local or network)
management specifying the set of ports to which
frames received from specific ports and containing
specific destination addresses are allowed to be
forwarded. The value of zero in this table as the
port number from which frames with a specific
destination address are received, is used to
specify all ports for which there is no specific
entry in this table for that particular
destination address. Entries are valid for
unicast and for group/broadcast addresses.' |
| Status: mandatory |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
SEQUENCE OF |
|
|
| |
|
WfDot1dStaticTableEntry |
|
| wfDot1dStaticTableEntry |
1.3.6.1.4.1.18.3.5.1.1.6.5.1.1 |
| 'Filtering information configured into the bridge
by (local or network) management specifying the
set of ports to which frames received from a
specific port and containing a specific
destination address are allowed to be forwarded.' |
| Status: mandatory |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
WfDot1dStaticTableEntry |
|
|
| wfDot1dStaticAddress |
1.3.6.1.4.1.18.3.5.1.1.6.5.1.1.1 |
| 'The destination MAC address in a frame to which
this entry's filtering information applies. This
object can take the value of a unicast address, a
group address or the broadcast address.' |
| Status: mandatory |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
OCTET STRING |
Size(6) |
|
| wfDot1dStaticReceivePort |
1.3.6.1.4.1.18.3.5.1.1.6.5.1.1.2 |
| 'Either the value '0', or the port number of the
port from which a frame must be received in order
for this entry's filtering information to apply.
A value of zero indicates that this entry applies
on all ports of the bridge for which there is no
other applicable entry.' |
| Status: mandatory |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
|
|
| wfDot1dStaticAllowedToGoTo |
1.3.6.1.4.1.18.3.5.1.1.6.5.1.1.3 |
| 'The set of ports to which frames received from a
specific port and destined for a specific MAC
address, are allowed to be forwarded. Each octet
within the value of this object specifies a set of
eight ports, with the first octet specifying ports
1 through 8, the second octet specifying ports 9
through 16, etc. Within each octet, the most
significant bit represents the lowest numbered
port, and the least significant bit represents the
highest numbered port. Thus, each port of the
bridge is represented by a single bit within the
value of this object. If that bit has a value of
'1' then that port is included in the set of
ports; the port is not included if its bit has a
value of '0'. (Note that the setting of the bit
corresponding to the port from which a frame is
received is irrelevant.)' |
| Status: mandatory |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
OCTET STRING |
|
|
| wfDot1dStaticStatus |
1.3.6.1.4.1.18.3.5.1.1.6.5.1.1.4 |
| 'This object indicates the status of this entry.
other(1) - this entry is currently in use but
the conditions under which it will
remain so are different from each of the
following values.
invalid(2) - writing this value to the object
removes the corresponding entry.
permanent(3) - this entry is currently in use
and will remain so after the next reset
of the bridge.
deleteOnReset(4) - this entry is currently in
use and will remain so until the next
reset of the bridge.
deleteOnTimeout(5) - this entry is currently
in use and will remain so until it is
aged out.' |
| Status: mandatory |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
other(1), invalid(2), permanent(3), reset(4), timeout(5) |
|