Copyright (c) 2012 IETF Trust and the persons identified
as the document authors. All rights reserved.
This MIB module contains generic object definitions for
MPLS LSR in transport networks.
An entry in this table extends the cross connect
information represented by an entry in
the mplsXCTable in MPLS-LSR-STD-MIB [RFC3813] through
a sparse augmentation. An entry can be created by
a network administrator via SNMP SET commands, or in
response to signaling protocol events.
This object indicates the back pointer to the tunnel
entry segment. This object cannot be modified if
mplsXCRowStatus for the corresponding entry in the
mplsXCTable is active(1).
This object indicates the pointer to the opposite
direction XC entry. This object cannot be modified if
mplsXCRowStatus for the corresponding entry in the
mplsXCTable is active(1).
Compliance statement for agents that provide full support
for MPLS-LSR-EXT-STD-MIB.
The mandatory group has to be implemented by all LSRs
that originate, terminate, or act as transit for
TE-LSPs/tunnels.
In addition, depending on the type of tunnels supported,
other groups become mandatory as explained below.
Compliance requirement for implementations that only
provide read-only support for MPLS-LSR-EXT-STD-MIB.
Such devices can then be monitored but cannot be
configured using this MIB module.
