Juniper-BRIDGE-ETHERNET-MIB
File:
Juniper-BRIDGE-ETHERNET-MIB.mib (11679 bytes)
Imported modules
Imported symbols
Defined Types
JuniBridgedEthernetIfEntry |
|
SEQUENCE |
|
|
|
|
juniBridgedEthernetIfIfIndex |
InterfaceIndex |
|
|
juniBridgedEthernetProxyArp |
INTEGER |
|
|
juniBridgedEthernetIfLowerIfIndex |
InterfaceIndexOrZero |
|
|
juniBridgedEthernetIfRowStatus |
RowStatus |
|
|
juniBridgedEthernetIfMtu |
Integer32 |
|
Defined Values
juniBridgeEthernetMIB |
1.3.6.1.4.1.4874.2.2.31 |
The Bridge Ethernet MIB for the Juniper Networks
enterprise. |
MODULE-IDENTITY |
|
|
|
juniBridgedEthernetNextIfIndex |
1.3.6.1.4.1.4874.2.2.31.1.1.1 |
Coordinate ifIndex value allocation for entries in
juniBridgedEthernetIfTable.
A GET of this object returns the next available ifIndex value to be used
to create an entry in the associated interface table; or zero, if no
valid ifIndex value is available. This object also returns a value of
zero when it is the lexicographic successor of a varbind presented in an
SNMP GETNEXT or GETBULK request, for which circumstance it is assumed
that ifIndex allocation is unintended.
Successive GETs will typically return different values, thus avoiding
collisions among cooperating management clients seeking to create table
entries simultaneously. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
JuniNextIfIndex |
|
|
juniBridgedEthernetIfEntry |
1.3.6.1.4.1.4874.2.2.31.1.1.2.1 |
The Parameters for a particular Bridged Ethernet interface.
Creating/deleting entries in this table causes corresponding entries for
be created/deleted in ifTable/ifXTable/juniIfTable. |
Status: current |
Access: not-accessible |
OBJECT-TYPE |
|
|
|
|
JuniBridgedEthernetIfEntry |
|
|
juniBridgedEthernetProxyArp |
1.3.6.1.4.1.4874.2.2.31.1.1.2.1.2 |
The proxyArp configuration setting for this entry.
*** NOTE: This MIB object has been obsoleted. *** |
Status: obsolete |
Access: read-create |
OBJECT-TYPE |
|
|
|
|
INTEGER |
enableRestricted(1), enableUnrestricted(2), disable(3) |
|
juniBridgedEthernetIfLowerIfIndex |
1.3.6.1.4.1.4874.2.2.31.1.1.2.1.3 |
The ifIndex of an interface over which this Bridged Ethernet interface
is to be layered. A value of zero indicates no layering. An
implementation may choose to require that a nonzero value be configured
at entry creation. |
Status: current |
Access: read-create |
OBJECT-TYPE |
|
|
|
|
InterfaceIndexOrZero |
|
|
juniBridgedEthernetIfRowStatus |
1.3.6.1.4.1.4874.2.2.31.1.1.2.1.4 |
Controls creation/deletion of entries in this table according to the
RowStatus textual convention, constrained to support the following
values only:
createAndGo
destroy
To create an entry in this table, the following entry objects MUST be
explicitly configured:
juniBridgedEthernetIfRowStatus
juniBridgedEthernetIfLowerIfIndex
In addition, when creating an entry the following conditions must hold:
A value for juniBridgedEthernetIfIndex must have been determined
previously, by reading juniBridgedEthernetNextIfIndex.
The interface identified by juniBridgedEthernetIfLowerIfIndex must
exist, and must be an interface type that permits layering of
Bridged Ethernet above it.
A corresponding entry in ifTable/ifXTable/juniIfTable is
created/destroyed as a result of creating/destroying an entry in this
table. |
Status: current |
Access: read-create |
OBJECT-TYPE |
|
|
|
|
RowStatus |
|
|
juniBridgedEthernetIfMtu |
1.3.6.1.4.1.4874.2.2.31.1.1.2.1.5 |
The configured maximum transfer unit (MTU) for this ethernet interface.
The operational value is reported in the corresponding Interfaces MIB
ifMtu object. |
Status: current |
Access: read-create |
OBJECT-TYPE |
|
|
|
|
Integer32 |
64..9180 |
|
juniBridgedEthernetCompliance |
1.3.6.1.4.1.4874.2.2.31.4.1.1 |
The compliance statement for entities which implement the Juniper
bridged Ethernet MIB. This statement became deprecated when
additional configuration for Bridged Ethernet was added. |
Status: deprecated |
Access: read-create |
MODULE-COMPLIANCE |
|
|
|
juniBridgedEthernetCompliance2 |
1.3.6.1.4.1.4874.2.2.31.4.1.2 |
The compliance statement for entities which implement the Juniper
bridged Ethernet MIB. |
Status: current |
Access: read-create |
MODULE-COMPLIANCE |
|
|
|
juniBridgedEthernetGroup |
1.3.6.1.4.1.4874.2.2.31.4.2.1 |
A collection of objects providing management of Bridged Ethernet
interfaces in a Juniper product. This group became obsolete when
juniBridgedEthernetProxyArp was made obsolete. |
Status: obsolete |
Access: read-create |
OBJECT-GROUP |
|
|
|
juniBridgedEthernetGroup2 |
1.3.6.1.4.1.4874.2.2.31.4.2.2 |
A collection of objects providing management of Bridged Ethernet
interfaces in a Juniper product. This group became deprecated
when the juniBridgedEthernetIfMtu object was added. |
Status: deprecated |
Access: read-create |
OBJECT-GROUP |
|
|
|
juniBridgedEthernetGroup3 |
1.3.6.1.4.1.4874.2.2.31.4.2.3 |
A collection of objects providing management of Bridged Ethernet
interfaces in a Juniper product. |
Status: current |
Access: read-create |
OBJECT-GROUP |
|
|
|