
| ASCEND-MIB | RFC1155-SMI | RFC-1212 |
| atmpGroup | DisplayString | IpAddress |
| Counter | OBJECT-TYPE |
| atmpAgentMode | 1.3.6.1.4.1.529.24.1 | ||
| The type of ATMP Agent. | |||
| OBJECT-TYPE | |||
| INTEGER | atmp-disabled(1), home-agent(2), foreign-agent(3), both-agent(4) | ||
| atmpAgentType | 1.3.6.1.4.1.529.24.2 | ||
| The type of ATMP HA Agent. ha-router means the HA will route the tunneled data to other networks. ha-gateway means the HA delivers tunneled data to other networks without routing anything. A ha-notapp will be returned for FA and if ATMP is disabled. | |||
| OBJECT-TYPE | |||
| INTEGER | ha-router(1), ha-gateway(2), ha-notapp(3) | ||
| atmpAgentUDPPort | 1.3.6.1.4.1.529.24.3 | ||
| UDP port number to be used for ATMP. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| atmpAgentGreMtu | 1.3.6.1.4.1.529.24.4 | ||
| The maximum IP packet size that can be transmitted to a peer agent without performing fragmentation. The value 0 means this feature is disabled. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| atmpAgentForceFragmentation | 1.3.6.1.4.1.529.24.5 | ||
| To force fragmentation of large IP frames before they are sent to the peer agent even if the packet has the DF bit set. NOTE: this behavior is not standard and prevents MTU discovery mechanisms. This works in conjunction with atmpAgentGreMtu. | |||
| OBJECT-TYPE | |||
| INTEGER | enabled(1), disabled(2) | ||
| atmpAgentHAIdleLimit | 1.3.6.1.4.1.529.24.6 | ||
| Time in minutes that the HA will allow a tunnel to have no traffic before tearing it down. The value 0 means this option is disabled. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| atmpLastErrorGenerated | 1.3.6.1.4.1.529.24.7 | ||
| This is the last error at the Agent level or Tunnel creation that was generated by the Agent. To clear the field and atmpAgentSentErrorTo do a set with the value no-error(1) | |||
| OBJECT-TYPE | |||
| INTEGER | no-error(1), fa-auth-failed(2), ha-atmp-disabled(3), too-many-tunnel(4), err-parameter(5), bad-tunnel(6), err-timeout(7), hn-unreachable(8), dns-failed(9), err-general(10) | ||
| atmpAgentSentErrorTo | 1.3.6.1.4.1.529.24.8 | ||
| The IP Address of the agent that the generated was sent to. Clearing atmpLastErrorGenerated also clears this field. | |||
| OBJECT-TYPE | |||
| IpAddress | |||
| atmpLastErrorRecv | 1.3.6.1.4.1.529.24.9 | ||
| This is the last error at the Agent level or Tunnel creation that was received from the Peer Agent. To clear the field and atmpAgentRecvErrorFrom do a set with the value no-error(1) | |||
| OBJECT-TYPE | |||
| INTEGER | no-error(1), fa-auth-failed(2), ha-atmp-disabled(3), too-many-tunnel(4), err-parameter(5), bad-tunnel(6), err-timeout(7), hn-unreachable(8) | ||
| atmpAgentRecvErrorFrom | 1.3.6.1.4.1.529.24.10 | ||
| The IP Address of the agent that the last error received was from. Clearing atmpLastErrorRecv also clears this field. | |||
| OBJECT-TYPE | |||
| IpAddress | |||
| atmpEnableAtmpTraps | 1.3.6.1.4.1.529.24.11 | ||
| Enable the atmp traps. | |||
| OBJECT-TYPE | |||
| INTEGER | enabled(1), disabled(2) | ||
| atmpAgentNumberFATunnels | 1.3.6.1.4.1.529.24.12 | ||
| The number of FA tunnels. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| atmpAgentNumberHATunnels | 1.3.6.1.4.1.529.24.13 | ||
| The number of HA tunnels. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| atmpAgentNumberLocalTunnels | 1.3.6.1.4.1.529.24.14 | ||
| The number of Local client mode tunnels. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| atmpAgentTunnelHighWater | 1.3.6.1.4.1.529.24.15 | ||
| The high water mark on created ATMP tunnels. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| atmpTunnelTable | 1.3.6.1.4.1.529.24.16 | ||
| A list of ATMP tunnel entries. | |||
| OBJECT-TYPE | |||
| SEQUENCE OF | |||
| AtmpTunnelEntry | |||
| atmpTunnelEntry | 1.3.6.1.4.1.529.24.16.1 | ||
| A ATMP tunnel entry. | |||
| OBJECT-TYPE | |||
| AtmpTunnelEntry | |||
| atmpTunnelIndex | 1.3.6.1.4.1.529.24.16.1.1 | ||
| A unique index assigned to this tunnel. | |||
| OBJECT-TYPE | |||
| INTEGER | 1..'7fffffff'h | ||
| atmpTunnelId | 1.3.6.1.4.1.529.24.16.1.2 | ||
| The tunnel ID assigned to this tunnel. This number is assigned by the HA. NOTE: this number does *not* uniquely identify a tunnel. | |||
| OBJECT-TYPE | |||
| INTEGER | 0..65535 | ||
| atmpHAIpAddress | 1.3.6.1.4.1.529.24.16.1.3 | ||
| The IP Address of this tunnel's HA. | |||
| OBJECT-TYPE | |||
| IpAddress | |||
| atmpFAIpAddress | 1.3.6.1.4.1.529.24.16.1.4 | ||
| The IP Address of this tunnel's FA. | |||
| OBJECT-TYPE | |||
| IpAddress | |||
| atmpTunneledProtocol | 1.3.6.1.4.1.529.24.16.1.5 | ||
| This value indicates the protocol(s) that the tunnel supports. The value is a sum. The sum initially takes the value zero. Then for each protocol that is supported, the value of the protocol is or'ed to the sum. Example: 3 means ip and ipx. | |||
| OBJECT-TYPE | |||
| INTEGER | ip(1), ipx(2) | ||
| atmpTunnelType | 1.3.6.1.4.1.529.24.16.1.6 | ||
| The type of tunnel this is. | |||
| OBJECT-TYPE | |||
| INTEGER | ha(1), fa(2), both(3) | ||
| atmpTunnelState | 1.3.6.1.4.1.529.24.16.1.7 | ||
| These are the states the tunnel can be in. | |||
| OBJECT-TYPE | |||
| INTEGER | registering(1), up(2), down(3) | ||
| atmpMnIpAddress | 1.3.6.1.4.1.529.24.16.1.8 | ||
| The IP Address of the Mobile Node. | |||
| OBJECT-TYPE | |||
| IpAddress | |||
| atmpMnNetmask | 1.3.6.1.4.1.529.24.16.1.9 | ||
| The netmask of the Mobile Node. | |||
| OBJECT-TYPE | |||
| IpAddress | |||
| atmpMnIpxNetAddress | 1.3.6.1.4.1.529.24.16.1.10 | ||
| The IPX network address of the Mobile Node. | |||
| OBJECT-TYPE | |||
| OCTET STRING | SIZE(4) | ||
| atmpMnIpxNodeAddress | 1.3.6.1.4.1.529.24.16.1.11 | ||
| The IPX node address of the Mobile Node. | |||
| OBJECT-TYPE | |||
| OCTET STRING | SIZE(6) | ||
| atmpHNProfileName | 1.3.6.1.4.1.529.24.16.1.12 | ||
| The name of the home network profile which will be used to forward all packets received by the HA. This may be NULL if the HA is in router mode. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| atmpHNMaxTunnels | 1.3.6.1.4.1.529.24.16.1.13 | ||
| The maximum number of tunnels allowed to this HN. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| atmpFAPrimaryHAAddress | 1.3.6.1.4.1.529.24.16.1.14 | ||
| The Address of the Primary HA. This is known on the FA and will be NULL if the tunnel is on the HA. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| atmpFASecondaryHAAddress | 1.3.6.1.4.1.529.24.16.1.15 | ||
| The Address of the secondary HA. This is known only on the FA and will be NULL if the tunnel is on the HA. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| atmpFASsnStatusIndex | 1.3.6.1.4.1.529.24.16.1.16 | ||
| The session status entry index. This is used to tie in the tunnel with a mobile node. It is the same as ssnStatusIndex. This is only known on the FA and will be 0 if the tunnel is on the HA. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| atmpFAUserName | 1.3.6.1.4.1.529.24.16.1.17 | ||
| The name of the mobile node. This is only known on the FA and will be NULL if the tunnel is on the HA. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| atmpInPkts | 1.3.6.1.4.1.529.24.16.1.18 | ||
| The number of packets received on this tunnel from the peer Agent. Not valid for tunnels in local client mode. | |||
| OBJECT-TYPE | |||
| Counter | |||
| atmpInOctets | 1.3.6.1.4.1.529.24.16.1.19 | ||
| The number of octets received on this tunnel from the peer Agent. Not valid for tunnels in local client mode. | |||
| OBJECT-TYPE | |||
| Counter | |||
| atmpInErrPkts | 1.3.6.1.4.1.529.24.16.1.20 | ||
| The number of packets received on this tunnel from the peer Agent that were dropped. Not valid for tunnels in local client mode. | |||
| OBJECT-TYPE | |||
| Counter | |||
| atmpOutPkts | 1.3.6.1.4.1.529.24.16.1.21 | ||
| The number of packets sent on this tunnel to the peer Agent. Not valid for tunnels in local client mode. | |||
| OBJECT-TYPE | |||
| Counter | |||
| atmpOutOctets | 1.3.6.1.4.1.529.24.16.1.22 | ||
| The number of octets sent on this tunnel to the peer Agent. Not valid for tunnels in local client mode. | |||
| OBJECT-TYPE | |||
| Counter | |||
| atmpOutErrPkts | 1.3.6.1.4.1.529.24.16.1.23 | ||
| The number of packets dropped on this tunnel before sending to peer Agent. Not valid for tunnels in local client mode. | |||
| OBJECT-TYPE | |||
| Counter | |||
| atmpPktsForcedToFragment | 1.3.6.1.4.1.529.24.16.1.24 | ||
| The number of packets forced to pre-fragment despite the DF bit. Not valid for tunnels in local client mode. | |||
| OBJECT-TYPE | |||
| Counter | |||
| atmpPktsFailedFragment | 1.3.6.1.4.1.529.24.16.1.25 | ||
| The number of packets that required to be fragmented but were dropped because atmpAgentForceFragemtnation was disable and the DF bit was set. Not valid for tunnels in local client mode. | |||
| OBJECT-TYPE | |||
| Counter | |||
| AtmpTunnelEntry | |||
| SEQUENCE | |||
| INTEGER as atmpTunnelIndex | |||
| INTEGER as atmpTunnelId | |||
| IpAddress as atmpHAIpAddress | |||
| IpAddress as atmpFAIpAddress | |||
| INTEGER as atmpTunneledProtocol | |||
| INTEGER as atmpTunnelType | |||
| INTEGER as atmpTunnelState | |||
| IpAddress as atmpMnIpAddress | |||
| IpAddress as atmpMnNetmask | |||
| OCTET STRING as atmpMnIpxNetAddress | |||
| OCTET STRING as atmpMnIpxNodeAddress | |||
| DisplayString as atmpHNProfileName | |||
| INTEGER as atmpHNMaxTunnels | |||
| DisplayString as atmpFAPrimaryHAAddress | |||
| DisplayString as atmpFASecondaryHAAddress | |||
| INTEGER as atmpFASsnStatusIndex | |||
| DisplayString as atmpFAUserName | |||
| Counter as atmpInPkts | |||
| Counter as atmpInOctets | |||
| Counter as atmpInErrPkts | |||
| Counter as atmpOutPkts | |||
| Counter as atmpOutOctets | |||
| Counter as atmpOutErrPkts | |||
| Counter as atmpPktsForcedToFragment | |||
| Counter as atmpPktsFailedFragment | |||