
| RFC1155-SMI | RFC-1212 | SNMPv2-TC |
| Counter | OBJECT-TYPE | PhysAddress |
| org | 1.3 | ||
| OBJECT IDENTIFIER | |||
| dod | 1.3.6 | ||
| OBJECT IDENTIFIER | |||
| internet | 1.3.6.1 | ||
| OBJECT IDENTIFIER | |||
| private | 1.3.6.1.4 | ||
| OBJECT IDENTIFIER | |||
| enterprises | 1.3.6.1.4.1 | ||
| OBJECT IDENTIFIER | |||
| bintec | 1.3.6.1.4.1.272 | ||
| OBJECT IDENTIFIER | |||
| bibo | 1.3.6.1.4.1.272.4 | ||
| OBJECT IDENTIFIER | |||
| tokenring | 1.3.6.1.4.1.272.4.11 | ||
| OBJECT IDENTIFIER | |||
| tokenringIfTable | 1.3.6.1.4.1.272.4.11.1 | ||
| The tokenringIfTable contains information relating to the interfaces found on the system. Each entry corresponds to a connected TokenRing interface. Entries can only be added or deleted by the system. Creating entries: Entries are created by the system only when a new TokenRing module is installed. Deleting entries: Entries are removed by the system after the appropriate TokenRing module is removed. | |||
| OBJECT-TYPE | |||
| SEQUENCE OF | |||
| TokenRingIfEntry | |||
| tokenringIfEntry | 1.3.6.1.4.1.272.4.11.1.1 | ||
| OBJECT-TYPE | |||
| TokenRingIfEntry | |||
| tokenringIfSlot | 1.3.6.1.4.1.272.4.11.1.1.1 | ||
| Unique Slot of the TokenRing interface. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| tokenringIfState | 1.3.6.1.4.1.272.4.11.1.1.2 | ||
| The TokenRing adapter initialization state | |||
| OBJECT-TYPE | |||
| INTEGER | down(1), start(2), download(3), reset(4), bud(5), tferipb(6), wait1(7), open(8), wait2(9), delay1(10), receive(11), wait3(12), done(13), close(14), error(15) | ||
| tokenringIfRingRate | 1.3.6.1.4.1.272.4.11.1.1.3 | ||
| speed of the token ring. | |||
| OBJECT-TYPE | |||
| INTEGER | tr-4Mbit(1), tr-16Mbit(2) | ||
| tokenringIfEarlyTokenRelease | 1.3.6.1.4.1.272.4.11.1.1.4 | ||
| enable or disable early token release. This feature is only valid with the 16 Mbps ring rate | |||
| OBJECT-TYPE | |||
| INTEGER | enabled(1), disabled(2) | ||
| tokenringIfWrapInterface | 1.3.6.1.4.1.272.4.11.1.1.5 | ||
| enable or disable the wrap interface option. If enabled the ring insertion process is omitted and all user-transmit data appears as receive data. | |||
| OBJECT-TYPE | |||
| INTEGER | enabled(1), disabled(2) | ||
| tokenringIfMtu | 1.3.6.1.4.1.272.4.11.1.1.6 | ||
| The size of the largest datagram which can be sent/received on the interface, specified in octets. | |||
| OBJECT-TYPE | |||
| INTEGER | 15..17800 | ||
| tokenringIfOverwritePhysAddress | 1.3.6.1.4.1.272.4.11.1.1.7 | ||
| The interface's address at the protocol layer immediately `below' the network layer in the protocol stack. This overwrites the address defined in the adapter PROM. | |||
| OBJECT-TYPE | |||
| PhysAddress | |||
| tokenringIfNAUN | 1.3.6.1.4.1.272.4.11.1.1.8 | ||
| The interface's address of the nearest upstream neighbour. | |||
| OBJECT-TYPE | |||
| PhysAddress | |||
| tokenringIfLineError | 1.3.6.1.4.1.272.4.11.1.1.9 | ||
| Count of line errors. This counter is incremented whenever 1) a frame is repeated or copied, and 2) the Error Detected Indicator (EDI) is zero in the incoming frame, and 3) at least one of the following conditions exists: a) a code violation between SDEL and EDEL b) a code violation in a token c) a FCS error | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfBurstError | 1.3.6.1.4.1.272.4.11.1.1.10 | ||
| Count of burst errors. This counter is incremented whenever the interface detects the absence of transitions for five half-bit times between SDEL and EDEL, or EDEL and SDEL | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfAriFciError | 1.3.6.1.4.1.272.4.11.1.1.11 | ||
| Count of ARI/FCI errors. This counter is incremented whenever the interface receives an Active Monitor Present (AMP) MAC frame with the ARI/FCI bit equal to zero and a Standby Monitor Present (SMP) MAC frame with the ARI/FCI bits equal to zero, or more than one SMP MAC frame with the ARI/FCI bits equal to zero, without receiving an intervening AMP MAC frame. | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfLostFrameError | 1.3.6.1.4.1.272.4.11.1.1.12 | ||
| Count of lost frames errors. This counter is incremented whenever the interface is in transmit (stripping) mode and fails to receive the end of the frame it transmitted | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfReceiveCongestionError | 1.3.6.1.4.1.272.4.11.1.1.13 | ||
| Count of receive congestion errors. This counter is incremented whenever the interface in the repeat mode recognizes a frame addressed to it but has no buffer space to copy the frame | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfFrameCopiedError | 1.3.6.1.4.1.272.4.11.1.1.14 | ||
| Count of frame copied errors. This counter is incremented whenever the interface in the receive/repeat mode recognizes a frame addressed to its specific address but finds the ARI bits not equal to zero | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfTokenError | 1.3.6.1.4.1.272.4.11.1.1.15 | ||
| Count of token errors. This counter is only active in the active monitor station. It is incremented when the active monitor detects an error in the token protocol | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfDmaBusError | 1.3.6.1.4.1.272.4.11.1.1.16 | ||
| Count of DMA bus errors. This counter is counts the occurences of DMA bus errors that do not exceed the specified abort thresholds | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfDmaParityError | 1.3.6.1.4.1.272.4.11.1.1.17 | ||
| Count of DMA parity errors. This counter counts the occurences of DMA parity errors that do not exceed the specified abort thresholds | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfSoftError | 1.3.6.1.4.1.272.4.11.1.1.18 | ||
| Count of soft errors that occur during normal operation. A soft error is an error condition that temporarily degrades system performance; however the ring recovers by using the protocols of the adapter. The adapter counts these errors and can report them to both the attached product and the ring error monitor. | |||
| OBJECT-TYPE | |||
| Counter | |||
| tokenringIfSourceRouting | 1.3.6.1.4.1.272.4.11.1.1.19 | ||
| enable or disable source routing. If enabled, a routing information field is added to the frame sent over this interface. | |||
| OBJECT-TYPE | |||
| INTEGER | enabled(1), disabled(2) | ||
| Date | |||
| INTEGER | |||
| HexValue | |||
| INTEGER | |||
| TokenRingIfEntry | |||
| SEQUENCE | |||
| INTEGER as tokenringIfSlot | |||
| INTEGER as tokenringState | |||
| INTEGER as tokenringIfRingRate | |||
| INTEGER as tokenringIfEarlyTokenRelease | |||
| INTEGER as tokenringIfWrapInterface | |||
| INTEGER as tokenringIfMtu | |||
| PhysAddress as tokenringIfOverwritePhysAddress | |||
| PhysAddress as tokenringIfNAUN | |||
| Counter as tokenringIfLineError | |||
| Counter as tokenringIfBurstError | |||
| Counter as tokenringIfAriFciError | |||
| Counter as tokenringIfLostFrameError | |||
| Counter as tokenringIfReceiveCongestionError | |||
| Counter as tokenringIfFrameCopiedError | |||
| Counter as tokenringIfTokenError | |||
| Counter as tokenringIfDmaBusError | |||
| Counter as tokenringIfDmaParityError | |||
| Counter as tokenringIfSoftError | |||
| INTEGER as tokenringIfSourceRouting | |||