
CASA-CABLE-CMCPE-MIB
File:
CASA-CABLE-CMCPE-MIB.mib (15784 bytes)
Imported modules
Imported symbols
Defined Objects
| casaMgmt |
1.3.6.1.4.1.20858.10 |
| OBJECT IDENTIFIER |
|
|
|
| casaCmtsUSModemEntry |
1.3.6.1.4.1.20858.10.12.1.1.1 |
| Index of the table is logical uptream channel ifIndex . |
| OBJECT-TYPE |
|
|
|
| |
CasaCmtsUSModemEntry |
|
|
| casaCmtsDSModemEntry |
1.3.6.1.4.1.20858.10.12.1.2.1 |
| Index of the table is downstream channel ifIndex . |
| OBJECT-TYPE |
|
|
|
| |
CasaCmtsDSModemEntry |
|
|
| casaCmtsCmCpeEntry |
1.3.6.1.4.1.20858.10.12.1.3.1 |
| The list contains information for a cable modem (CM) or a Customer Premises Equipment (CPE). An entry exist for each cable modem supported by CMTS and each Customer Premises Equipment connected to a cable modem supported by CMTS. |
| OBJECT-TYPE |
|
|
|
| |
CasaCmtsCmCpeEntry |
|
|
| casaCmtsCmCpeType |
1.3.6.1.4.1.20858.10.12.1.3.1.2 |
| ndicate this entry is for cable modem or Customer Premises Equipment. The enumerations are: cm(1): cable modem cpe(2): Customer Premises Equipment |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
cm(1), cpe(2) |
|
| casaCmtsCmCpeIfIndex |
1.3.6.1.4.1.20858.10.12.1.3.1.4 |
| The CMTS cable MAC interface index (ifType of docsCableMaclayer(127)) that cable modem or Customer Premises Equipment connects to. Use casaCmtsCmCpeIfIndex and casaCmtsCmCpeCmtsServiceId to identify an entry in docsIfCmtsServiceTable. |
| OBJECT-TYPE |
|
|
|
| |
InterfaceIndex |
|
|
| casaCmtsCmCpeCmtsServiceId |
1.3.6.1.4.1.20858.10.12.1.3.1.5 |
| The cable modem's primary Service ID if the type is cm. The primary Service ID for the CM which the CPE connects if the type is cpe. Use casaCmtsCmCpeIfIndex and casaCmtsCmCpeCmtsServiceId to identify an entry in docsIfCmtsServiceTable. |
| OBJECT-TYPE |
|
|
|
| |
Integer32 |
1..16383 |
|
| casaCmtsCmCpeResetNow |
1.3.6.1.4.1.20858.10.12.1.3.1.7 |
| Setting this object to true(1) causes the device to reset. Reading this object always returns false(2). For casaCmtsCmCpeType value cm(1), CMTS removes the CM from the Station Maintenance List and would cause the CM to reset its interface. For casaCmtsCmCpeType value cpe(2), CMTS removes the CPE's MAC address from the internal address table. It then rediscovers and associates the CPE with the correct CM during the next DHCP lease cycle. By resetting the CPE, the user can replace an existing CPE or change its network interface card (NIC) |
| OBJECT-TYPE |
|
|
|
| |
TruthValue |
|
|
| casaCmtsCpeIpNetToPhysicalEntry |
1.3.6.1.4.1.20858.10.12.1.4.1 |
| Each entry contains one IP address to `physical' address equivalence.. |
| OBJECT-TYPE |
|
|
|
| |
CasaCmtsCpeIpNetToPhysicalEntry |
|
|
| casaCmtsCpeIpNetToPhysicalIfIndex |
1.3.6.1.4.1.20858.10.12.1.4.1.1 |
| The index value that uniquely identifies the interface to which this entry is applicable. The interface identified by a particular value of this index is the same interface as identified by the same value of the IF-MIB's ifIndex. |
| OBJECT-TYPE |
|
|
|
| |
InterfaceIndex |
|
|
| casaCmtsCpeIpNetToPhysicalType |
1.3.6.1.4.1.20858.10.12.1.4.1.7 |
| The type of mapping. Setting this object to the value invalid(2) has the effect of invalidating the corresponding entry in the ipNetToPhysicalTable. That is, it effectively dis- associates the interface identified with said entry from the mapping identified with said entry. It is an implementation-specific matter as to whether the agent removes an invalidated entry from the table. Accordingly, management stations must be prepared to receive tabular information from agents that corresponds to entries not currently in use. Proper interpretation of such entries requires examination of the relevant ipNetToPhysicalType object. The 'dynamic(3)' type indicates that the IP address to physical addresses mapping has been dynamically resolved using e.g., IPv4 ARP or the IPv6 Neighbor Discovery protocol. The 'static(4)' type indicates that the mapping has been statically configured. Both of these refer to entries that provide mappings for other entities addresses. The 'local(5)' type indicates that the mapping is provided for an entity's own interface address. As the entries in this table are typically not persistent when this object is written the entity SHOULD NOT save the change to non-volatile storage. |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
other(1), invalid(2), dynamic(3), static(4) |
|
Defined Objects
| CasaCmtsUSModemEntry |
|
| SEQUENCE |
|
|
|
| |
Unsigned32 as casaCmtsUSActiveModemCount |
|
|
| |
Unsigned32 as casaCmtsUSRegisteredModemCount |
|
|
| |
Unsigned32 as casaCmtsUSTotalModemCount |
|
|
| CasaCmtsDSModemEntry |
|
| SEQUENCE |
|
|
|
| |
Unsigned32 as casaCmtsDSActiveModemCount |
|
|
| |
Unsigned32 as casaCmtsDSRegisteredModemCount |
|
|
| |
Unsigned32 as casaCmtsDSTotalModemCount |
|
|
| CasaCmtsCmCpeEntry |
|
| SEQUENCE |
|
|
|
| |
MacAddress as casaCmtsCmCpeMacAddress |
|
|
| |
INTEGER as casaCmtsCmCpeType |
|
|
| |
IpAddress as casaCmtsCmCpeIpAddress |
|
|
| |
InterfaceIndex as casaCmtsCmCpeIfIndex |
|
|
| |
Integer32 as casaCmtsCmCpeCmtsServiceId |
|
|
| |
Integer32 as casaCmtsCmCpeCmStatusIndex |
|
|
| |
TruthValue as casaCmtsCmCpeResetNow |
|
|
| CasaCmtsCpeIpNetToPhysicalEntry |
|
| SEQUENCE |
|
|
|
| |
InterfaceIndex as casaCmtsCpeIpNetToPhysicalIfIndex |
|
|
| |
InetAddressType as casaCmtsCpeIpNetToPhysicalNetAddressType |
|
|
| |
InetAddress as casaCmtsCpeIpNetToPhysicalNetAddress |
|
|
| |
PhysAddress as casaCmtsCpeIpNetToPhysicalCmPhysAddress |
|
|
| |
INTEGER as casaCmtsCpeIpNetToPhysicalType |
|
|