CENTILLION-IF-EXTENSIONS-MIB

File: CENTILLION-IF-EXTENSIONS-MIB.mib (8645 bytes)

Imported modules

RFC-1212 CENTILLION-ROOT-MIB RFC1155-SMI

Imported symbols

OBJECT-TYPE extensions BitField
Boolean EnableIndicator MacAddress
Counter

Defined Objects

cnIfExtensions 1.3.6.1.4.1.930.3.2
OBJECT IDENTIFIER    

cnIfExtnTable 1.3.6.1.4.1.930.3.2.1
A list of interface entries. The numebr of entries is given by the value of ifNumber.
OBJECT-TYPE    
  SEQUENCE OF  
    CnIfExtnEntry

cnIfExtnEntry 1.3.6.1.4.1.930.3.2.1.1
An interface entry containing objects at the subnetwork layer and below for a particular interface.
OBJECT-TYPE    
  CnIfExtnEntry  

cnIfExtnIndex 1.3.6.1.4.1.930.3.2.1.1.1
A unique value for each interface corresponding to the ifIndex value for the same interface.
OBJECT-TYPE    
  INTEGER  

cnIfExtnCardNumber 1.3.6.1.4.1.930.3.2.1.1.2
The card number associated with this particular interface.
OBJECT-TYPE    
  INTEGER  

cnIfExtnPortNumber 1.3.6.1.4.1.930.3.2.1.1.3
The port number associated with this particular interface.
OBJECT-TYPE    
  INTEGER  

cnIfFilterEnable 1.3.6.1.4.1.930.3.2.1.1.4
The state of filtering on this port. The filter port table will become valid when filters are is downloaded to the port via setting the cnIfFilterDownload object. In the high-perfomrance mode, filters will be disable on all ports execpt the management port.
OBJECT-TYPE    
  INTEGER enableInputFiltersOnly(1), disableAllFilters(2), enableOutputFiltersOnly(3), enableInputAndOutputFilters(4)  

cnIfFilterDownload 1.3.6.1.4.1.930.3.2.1.1.5
Downloads the filters to the port. Value will always be read as zero.
OBJECT-TYPE    
  BitField  

cnIfNetbiosNameFilteringState 1.3.6.1.4.1.930.3.2.1.1.6
The state of NetBIOS name filtering on this port. Note that a port with filtering disabled may have a valid NetBIOS name table. The table will become valid when filtering is enabled on the port.
OBJECT-TYPE    
  EnableIndicator  

cnIfNetbiosBcastDiscard 1.3.6.1.4.1.930.3.2.1.1.7
This indicates whether NetBIOS broadcasts are to be discarded on this interface.
OBJECT-TYPE    
  Boolean  

cnIfNetbiosNameProxyState 1.3.6.1.4.1.930.3.2.1.1.8
The state of NetBIOS name proxying on this port.
OBJECT-TYPE    
  EnableIndicator  

cnIfForwardingIdentifier 1.3.6.1.4.1.930.3.2.1.1.9
This object references the correspsonding instance in the MIB object which describes the ports forwarding function. For example, if the port is participating in bridging, then this object contains the OID of the bridgeGroupPortTable. If this information is not present, its value is set to the OBJECT IDENTIFIER { 0 0 }.
OBJECT-TYPE    
  OBJECT IDENTIFIER  

cnIfInNoResources 1.3.6.1.4.1.930.3.2.1.1.10
The number of inbound packet which were dropped by the switch because of lack of certain type of system resource.
OBJECT-TYPE    
  Counter  

cnIfOutNoResources 1.3.6.1.4.1.930.3.2.1.1.11
The number of outbound packet which were dropped by the switch because of lack of certain type of system resource.
OBJECT-TYPE    
  Counter  

cnIfVlanMismatch 1.3.6.1.4.1.930.3.2.1.1.12
The number of packets which were dropped due to the switch not being able to qualify a packet based on the VLAN policies defined. This object is only valid on interfaces that represent LAN physical port.
OBJECT-TYPE    
  Counter  

cnIfVlanCapabilities 1.3.6.1.4.1.930.3.2.1.1.13
This object contains bit mask flags to indicate support for port-based VLAN, 802.1Q Tagging, and protocol-based VLAN on a port. Bit definition: bit 0: port-based VLAN bit 1: 802.1Q Tagging bit 2: protocol-based VLAN bit 3-7:future use.
OBJECT-TYPE    
  OCTET STRING SIZE(1)  

cnIfExtnLocalAdminAddress 1.3.6.1.4.1.930.3.2.1.1.14
The interface's locally administed address if applicable. The interface's media-specific MIB must define the bit and byte ordering and format of the value contained by this object. For interfaces which do not have such an address (e.g., a serial line), this object should contain an octet string of zero length.
OBJECT-TYPE    
  MacAddress  

cnIfExtnPhyAddressDefault 1.3.6.1.4.1.930.3.2.1.1.15
This object refers to which mac address is being used: the default or locally administered address. The value of useLocallyAdministeredAddress(2) is read-only. Setting this object with useDefaultPhyAddress(1) will have the effect of deleting the locally administered address. It cannot be restored.
OBJECT-TYPE    
  INTEGER useDefaultPhyAddress(1), useLocallyAdministeredAddress(2)  

cnIfVlanTrunk 1.3.6.1.4.1.930.3.2.1.1.16
This object controls the VLAN trunk mode for the interface. In trunk mode, the interface accepts both tagged and untagged frames in its default VLAN. Trunk mode is only available for interfaces that support 802.1Q tagging, as indicated by cnIfVlanCapabilities. An interface in trunk mode cannot do protocol-based VLAN classification. The trunk mode cannot be changed while the interface belongs to an MLT group.
OBJECT-TYPE    
  EnableIndicator  

cnIfUsrInDiscards 1.3.6.1.4.1.930.3.2.1.1.17
The total number of inbound packets which were dropped by user-defined filters.
OBJECT-TYPE    
  Counter  

cnIfUsrOutDiscards 1.3.6.1.4.1.930.3.2.1.1.18
The total number of outbound packets which were dropped by user-defined filters.
OBJECT-TYPE    
  Counter  

Defined Objects

CnIfExtnEntry  
SEQUENCE    
  INTEGER as cnIfExtnIndex  
  INTEGER as cnIfExtnCardNumber  
  INTEGER as cnIfExtnPortNumber  
  INTEGER as cnIfFilterEnable  
  BitField as cnIfFilterDownload  
  EnableIndicator as cnIfNetbiosNameFilteringState  
  Boolean as cnIfNetbiosBcastDiscard  
  EnableIndicator as cnIfNetbiosNameProxyState  
  OBJECT IDENTIFIER as cnIfForwardingIdentifier  
  Counter as cnIfInNoResources  
  Counter as cnIfOutNoResources  
  Counter as cnIfVlanMismatch  
  OCTET STRING as cnIfVlanCapabilities  
  MacAddress as cnIfExtnLocalAdminAddress  
  INTEGER as cnIfExtnPhyAddressDefault  
  EnableIndicator as cnIfVlanTrunk  
  Counter as cnIfUsrInDiscards  
  Counter as cnIfUsrOutDiscards