
CISCO-FCOE-MIB
File:
CISCO-FCOE-MIB.mib (22869 bytes)
Imported modules
Imported symbols
Defined Objects
| ciscoFCoEMIB |
1.3.6.1.4.1.9.9.673 |
| This MIB module is for configuring and monitoring Fibre Channel over Ethernet (FCoE) related entities. This MIB defines the Virtual FC (VFC) Interface as an object that represents either a VF_Port or a VE_Port on the FCF. Virtual FC interfaces can be either statically created or dynamically created at the time of FIP based FLOGI or ELP request. In this document the term VSAN ID is used interchangeably with Fabric Index defined in the T11 standards. Terminologies used in this MIB are defined by the T11 FCoE standard. Refer to www.t11.org. This MIB also supports configuration of the following objects: - Mapping of FCoE VLAN ID used to carry traffic for a VSAN ID - FC-MAP value used by the FCF operating in FPMA mode - FIP snooping related objects |
| MODULE-IDENTITY |
|
|
|
| cfcoeCfgEntry |
1.3.6.1.4.1.9.9.673.1.1.1.1 |
| There is one entry in this table for each Fibre Channel management instance. |
| OBJECT-TYPE |
|
|
|
| |
CfcoeCfgEntry |
|
|
| cfcoeCfgFcmap |
1.3.6.1.4.1.9.9.673.1.1.1.1.1 |
| This object configures the FC-MAP value used by the FCF when operating in FPMA mode. The default value is 0EFC00h, as written in the standard. |
| OBJECT-TYPE |
|
|
|
| |
OCTET STRING |
SIZE(3) |
|
| cfcoeCfgDynamicVfcCreation |
1.3.6.1.4.1.9.9.673.1.1.1.1.2 |
| This object allows the user to enable (TRUE) or disable (FALSE) dynamic VFC interface creation on the FCF. When set to TRUE VFC interfaces are dynamically created when a FIP based FLOGI or ELP request is received. |
| OBJECT-TYPE |
|
|
|
| |
TruthValue |
|
|
| cfcoeCfgDefaultFCFPriority |
1.3.6.1.4.1.9.9.673.1.1.1.1.4 |
| The FIP priority value advertised by the FCF to ENodes by default. cfcoeStaticVfcFCFPriority configured for a VFC interface overrides this setting for the ENode associated with the VFC. |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
0..255 |
|
| cfcoeCfgDATov |
1.3.6.1.4.1.9.9.673.1.1.1.1.5 |
| The Discovery_Advertisement_Timeout value configured for the FCF. This is used as the timeout value in seconds by the FCF to send periodic Discovery Advertisements. |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
1..60 |
|
| cfcoeCfgAddressingMode |
1.3.6.1.4.1.9.9.673.1.1.1.1.6 |
| Addressing mode(s) supported by the FCF. Implementations should fail set requests for unsupported modes. |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
fpma(1), spma(2), both(3) |
|
| cfcoeVLANTable |
1.3.6.1.4.1.9.9.673.1.1.2 |
| This table facilitates configuration of VLAN and Fabric (VSAN) associations in an FCoE network. FCoE forwarding for a fabric is over a VLAN in a L2 Ethernet network. That is, reachability between the ENode/remote-FCF and an FCF for a given fabric is determined by the reachability provided by the Ethernet network on the corresponding VLAN. An active entry in this table indicates the VLAN that is used to transport FCoE traffic for a certain VSAN. Some implmentations may allow traffic from only one VSAN to be transported over a given VLAN. Such implmentations should prevent multiple entries with the same VLAN ID or the VSAN ID from being created in this table. Modifying existing VLAN-VSAN associations is not supported. Entries must be deleted first and then recreated. |
| OBJECT-TYPE |
|
|
|
| |
SEQUENCE OF |
|
|
| |
|
CfcoeVLANEntry |
|
| cfcoeVLANEntry |
1.3.6.1.4.1.9.9.673.1.1.2.1 |
| There is one entry in this table for each VLAN that is designated to transport FCoE traffic for a given fabric (VSAN). |
| OBJECT-TYPE |
|
|
|
| |
CfcoeVLANEntry |
|
|
| cfcoeFabricIndex |
1.3.6.1.4.1.9.9.673.1.1.2.1.2 |
| This object identifies the Fabric Index of the VSAN traffic for which can be transported over the VLAN identified by cfcoeVLANIndex. |
| OBJECT-TYPE |
|
|
|
| |
T11FabricIndex |
|
|
| cfcoeVLANOperState |
1.3.6.1.4.1.9.9.673.1.1.2.1.3 |
| Operational state of this VLAN-VSAN association entry. The 'up' state is achieved when both the VSAN and VLAN are valid. |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
up(1), down(2) |
|
| cfcoeStaticVfcTable |
1.3.6.1.4.1.9.9.673.1.1.3 |
| This table facilitates the creation and deletion of static VFC interfaces. While VFCs can be dynamically created based on FIP FLOGI/ELP requests users may want to associate certain pre-configured policy for a particular ENode or a remote-FCF. In such cases static VFC creation becomes necessary. In addition to creating a static VFC it also needs to be associated to an ENode or remote-FCF. The VFC binding provides such an associaton. Binding may occur after a VFC is created. |
| OBJECT-TYPE |
|
|
|
| |
SEQUENCE OF |
|
|
| |
|
CfcoeStaticVfcEntry |
|
| cfcoeStaticVfcEntry |
1.3.6.1.4.1.9.9.673.1.1.3.1 |
| There is one entry in this table for each statically created VFC Interface. |
| OBJECT-TYPE |
|
|
|
| |
CfcoeStaticVfcEntry |
|
|
| cfcoeStaticVfcBindType |
1.3.6.1.4.1.9.9.673.1.1.3.1.3 |
| The mechanism to identify the ENode associated with this VFC if it is of type VF_Port or to identify the remote-FCF associated with this VFC if it is of type VE_Port. |
| OBJECT-TYPE |
|
|
|
| |
VfcBindType |
|
|
| cfcoeStaticVfcBindIfIndex |
1.3.6.1.4.1.9.9.673.1.1.3.1.4 |
| This object allows for configuration of ifIndex of the ethernet interface over which the FCF reaches the ENode or the remote-FCF that this VFC identifies. This object is to be used only when the ENode or the remote-FCF is directly connected to the FCF over a specific ethernet interface. If the ENode or remote-FCF is not directly connected to the FCF, this field must be set to zero. |
| OBJECT-TYPE |
|
|
|
| |
InterfaceIndexOrZero |
|
|
| cfcoeStaticVfcBindMACAddress |
1.3.6.1.4.1.9.9.673.1.1.3.1.5 |
| This object allows the user to configure MAC address of the ENode or the remote-FCF that this VFC interface identifies. An ENode or remote-FCF is associated to this VFC only if the source MAC address in the FIP frames matches with this object. |
| OBJECT-TYPE |
|
|
|
| |
MacAddress |
|
|
| cfcoeStaticVfcRowStatus |
1.3.6.1.4.1.9.9.673.1.1.3.1.9 |
| The status of this conceptual row. The RowStatus becomes active on successful creation of a virtual interface. The VFC must be bound before it can become operational. |
| OBJECT-TYPE |
|
|
|
| |
RowStatus |
|
|
| cfcoeFipSnoopingEnable |
1.3.6.1.4.1.9.9.673.1.2.1 |
| This object is used to enable or disable FIP Snooping on an Ethernet Bridge. |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
enable(1), disable(2) |
|
| cfcoeFipSnoopingFcmap |
1.3.6.1.4.1.9.9.673.1.2.2 |
| This object configures the FC-MAP value associated with the FIP snooping Ethernet bridge. |
| OBJECT-TYPE |
|
|
|
| |
OCTET STRING |
SIZE(3) |
|
| cfcoeEnodeIntfTable |
1.3.6.1.4.1.9.9.673.1.2.3 |
| The (conceptual) table containing the interfaces on an Ethernet bridge that are directly connected to ENodes. A FIP Snooping bridge will automatically configure ACLs on these interfaces based on FIP login requests and responses. |
| OBJECT-TYPE |
|
|
|
| |
SEQUENCE OF |
|
|
| |
|
CfcoeEnodeIntfEntry |
|
| cfcoeEnodeIntfEntry |
1.3.6.1.4.1.9.9.673.1.2.3.1 |
| An entry (conceptual row) in the cfcoeEnodeIntfTable, representing an interface directly connected to an ENode on the Ethernet Bridge. |
| OBJECT-TYPE |
|
|
|
| |
CfcoeEnodeIntfEntry |
|
|
Defined Objects
| VfcBindType |
|
| Defines the different methods to identify (or bind to) - the ENode associated with a particular VF_Port VFC - the remote-FCF associated with a particular VE_Port VFC interfaceIndex(1) - This type is used when the ifIndex of an ethernet interface over which the FCF reaches the ENode or the remote-FCF is used to identify the ENode or the remote-FCF. This type is to be used only when the ENode or the remote-FCF is directly connected to the FCF over a specific ethernet interface. macAddress(2) - This type is used when the ENode or the remote-FCF is reachable by the FCF over a L2 Ethernet network. An ENode or remote-FCF is associated to a VFC only if the source MAC address in the FIP frames matches with the bound MAC Address on the VFC. |
| TEXTUAL-CONVENTION |
|
|
|
| |
INTEGER |
interfaceIndex(1), macAddress(2) |
|
| CfcoeCfgEntry |
|
| SEQUENCE |
|
|
|
| |
OCTET STRING as cfcoeCfgFcmap |
|
|
| |
TruthValue as cfcoeCfgDynamicVfcCreation |
|
|
| |
Unsigned32 as cfcoeCfgDynamicVfcAgeTimer |
|
|
| |
Unsigned32 as cfcoeCfgDefaultFCFPriority |
|
|
| |
Unsigned32 as cfcoeCfgDATov |
|
|
| |
INTEGER as cfcoeCfgAddressingMode |
|
|
| CfcoeVLANEntry |
|
| SEQUENCE |
|
|
|
| |
VlanIndex as cfcoeVLANIndex |
|
|
| |
T11FabricIndex as cfcoeFabricIndex |
|
|
| |
INTEGER as cfcoeVLANOperState |
|
|
| |
RowStatus as cfcoeVLANRowStatus |
|
|
| CfcoeStaticVfcEntry |
|
| SEQUENCE |
|
|
|
| |
Unsigned32 as cfcoeStaticVfcIndex |
|
|
| |
Unsigned32 as cfcoeStaticVfcFCFPriority |
|
|
| |
VfcBindType as cfcoeStaticVfcBindType |
|
|
| |
InterfaceIndexOrZero as cfcoeStaticVfcBindIfIndex |
|
|
| |
MacAddress as cfcoeStaticVfcBindMACAddress |
|
|
| |
InterfaceIndex as cfcoeStaticVfcIfIndex |
|
|
| |
TimeStamp as cfcoeStaticVfcCreationTime |
|
|
| |
SnmpAdminString as cfcoeStaticVfcFailureCause |
|
|
| |
RowStatus as cfcoeStaticVfcRowStatus |
|
|
| CfcoeEnodeIntfEntry |
|
| SEQUENCE |
|
|
|
| |
InterfaceIndex as cfcoeEnodeIntfIfIndex |
|
|
| |
RowStatus as cfcoeEnodeIntfRowStatus |
|
|