
CISCO-NDE-MIB
File:
CISCO-NDE-MIB.mib (7479 bytes)
Imported modules
Imported symbols
Defined Objects
| ciscoNDEMIB |
1.3.6.1.4.1.9.9.226 |
| The Netflow Data Export (NDE) MIB provides instrumentation for configuration and operation of the Netflow Data Export feature. A network flow is defined as an unidirectional sequence of packets between a given source and destination endpoints. Network flows are highly granular; flow endpoints are identified both by IP address as well as by transport layer application port numbers. NetFlow also utilizes the IP Protocol type, Type of Service (ToS) and the input interface identifier to uniquely identify flows. Netflow Data Export refers to the export of Netflow Data using UDP packets to Netflow Data Collector(s). A NetFlow Data Collector (NDC) captures, filters, aggregates, and stores the data from multiple NetFlow enabled devices. NDCs provide fast, scalable, and economical Netflow data. |
| MODULE-IDENTITY |
|
|
|
| cndeMaxCollectors |
1.3.6.1.4.1.9.9.226.1.1.1 |
| Maximum number of entries allowed in the cndeCollectorTable. A zero indicates unlimitted number of entries. The agent should set this value during initialization, and the vaule for this object cannot be changed during the system's operation |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
|
|
| cndeCollectorTable |
1.3.6.1.4.1.9.9.226.1.1.2 |
| A control table to configure the NDE collectors. The maximum number of entries is limited by cndeMaxCollectors. The agent sends the NDE packets to each address configured in this table. |
| OBJECT-TYPE |
|
|
|
| |
SEQUENCE OF |
|
|
| |
|
CndeCollectorEntry |
|
| cndeCollectorEntry |
1.3.6.1.4.1.9.9.226.1.1.2.1 |
| A conceptual row in the cndeCollectorEntry. |
| OBJECT-TYPE |
|
|
|
| |
CndeCollectorEntry |
|
|
| cndeMIBCompliance |
1.3.6.1.4.1.9.9.226.3.1.1 |
| The compliance statement for the CISCO-NDE-MIB. Objects used in an INDEX clause normally have a MAX-ACCESS of 'not-accessible', and the SMIv2 does not allow 'not-accessible' objects to be included in a GROUP clause. Consequently, a minimum syntax cannot be specified for them in an OBJECT clause. So, the following minimum compliance is specified within this DESCRIPTION clause: --OBJECT cndeCollectorAddressType --SYNTAX InetAddressType { ipv4(1) } --DESCRIPTION -- An implementation is only required to support IPv4 -- addresses. --OBJECT cndeCollectorAddress --SYNTAX InetAddress { SIZE(4) } --DESCRIPTION -- An implementation is only required to support IPv4 -- addresses. |
| MODULE-COMPLIANCE |
|
|
|
Defined Objects
| CndeCollectorEntry |
|
| SEQUENCE |
|
|
|
| |
InetAddressType as cndeCollectorAddressType |
|
|
| |
InetAddress as cndeCollectorAddress |
|
|
| |
Integer32 as cndeCollectorPort |
|
|
| |
RowStatus as cndeCollectorStatus |
|
|