
CTRON-TIMED-RESET-MIB
File:
CTRON-TIMED-RESET-MIB.mib (3914 bytes)
Imported modules
Imported symbols
Defined Objects
| ctTimedResetStatus |
1.3.6.1.4.1.52.4.1.1.5.2.1 |
| softEnabled(1) - soft reset in ctTimedResetTimeEntered seconds. hardEnabled(2) - hard reset in ctTimedResetTimeEntered seconds. A zero value in ctTimedResetTimeEntered will cause an immediate reset. Setting this to disabled(0) will cause any currently enabled timed reset will be disabled. |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
disabled(0), softEnabled(1), hardEnabled(2) |
|
| ctTimedResetTimeEntered |
1.3.6.1.4.1.52.4.1.1.5.2.2 |
| The time, in seconds, from the time ctTimedResetStatus is set to softEnabled(1) or hardEnabled(2), until the board will reset. |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
|
|
| ctTimedResetTimeRemaining |
1.3.6.1.4.1.52.4.1.1.5.2.3 |
| The time, in seconds, remaining until a reset will occur. The time is not meaningful if ctTimedResetStatus is disabled(0). |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
|
|
| ctTimedResetOperationalMode |
1.3.6.1.4.1.52.4.1.1.5.2.4 |
| The operational mode to run in when a timed reset occurs. When set to currentMode(0), the operational mode will remain unchanged. When set to ieee8021Q(1), the operational mode will be 802.1Q Switching. When set to secureFast(2), the operational mode will be Secure Fast VLAN. |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
currentMode(0), ieee8021Q(1), secureFast(2) |
|
| ctTimedResetNVRamReset |
1.3.6.1.4.1.52.4.1.1.5.2.5 |
| dontResetNVRam(0) - NVRAM will not be cleared on timed reset. resetNVRam(1) - NVRAM will be cleared on timed reset. |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
dontResetNVRam(0), resetNVRam(1) |
|