
| RFC1213-MIB | RFC1155-SMI | RFC-1212 |
| CTRON-MIB-NAMES |
| DisplayString | Counter | TimeTicks |
| OBJECT-TYPE | ctTrapLog |
| totalNumberOfEntries | 1.3.6.1.4.1.52.4.1.44.1 | ||
| Total number of logged entries for this chassis. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| configTable | 1.3.6.1.4.1.52.4.1.44.2 | ||
| OBJECT-TYPE | |||
| SEQUENCE OF | |||
| ConfigTableEntry | |||
| configTableEntry | 1.3.6.1.4.1.52.4.1.44.2.1 | ||
| Each entry allows a user to configure the alarm table for a specific slot. Objects such as Current Entry, MaxEntries Allowed, and an Enable/Disable switch are available. | |||
| OBJECT-TYPE | |||
| ConfigTableEntry | |||
| slotInChassis | 1.3.6.1.4.1.52.4.1.44.2.1.1 | ||
| Each Slot can be separately configured. This is the slot number for the configuration entry. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| numEntriesLoggeds | 1.3.6.1.4.1.52.4.1.44.2.1.2 | ||
| This is the total number of entries looged for this slot. | |||
| OBJECT-TYPE | |||
| Counter | |||
| numEntriesRequested | 1.3.6.1.4.1.52.4.1.44.2.1.3 | ||
| Maximum number of entries to store before wrapping the log on this slot. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| numEntriesAllocated | 1.3.6.1.4.1.52.4.1.44.2.1.4 | ||
| This is the number of entries allocated to log alarms on this slot. It will always be less than or equal to the requested number of entries. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| lastLoggedEntryLogId | 1.3.6.1.4.1.52.4.1.44.2.1.5 | ||
| This is the log id of the last entry logged for this slot. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| logCommand | 1.3.6.1.4.1.52.4.1.44.2.1.6 | ||
| Allows the user to send the log the commands specified in the enumeration. | |||
| OBJECT-TYPE | |||
| INTEGER | clearLog(1) | ||
| wrap | 1.3.6.1.4.1.52.4.1.44.2.1.7 | ||
| This is whether or not this configuration has wrapped or not. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| trapLogTable | 1.3.6.1.4.1.52.4.1.44.3 | ||
| OBJECT-TYPE | |||
| SEQUENCE OF | |||
| TrapLogEntry | |||
| trapLogEntry | 1.3.6.1.4.1.52.4.1.44.3.1 | ||
| Each alarm entry is generated from one of the following sources; (1) a module in one of the main chassis slots, (2) the EM, (3) or a power supply. | |||
| OBJECT-TYPE | |||
| TrapLogEntry | |||
| logId | 1.3.6.1.4.1.52.4.1.44.3.1.1 | ||
| Each slot has a maximium number of log entries that it can support. Each entry is assigned a monotonically increasing sequence number. When the maximum number of entries for a slot is reached, the log wraps. Each new entry will replace the oldest entry for that slot. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| nvmpId | 1.3.6.1.4.1.52.4.1.44.3.1.2 | ||
| This contains the nvmp id of the trap that occurred. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| trapLogAcknowledged | 1.3.6.1.4.1.52.4.1.44.3.1.3 | ||
| This field is set to 2 if a trap as been acknowledged from the EM. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| trapLogVarBind | 1.3.6.1.4.1.52.4.1.44.3.1.4 | ||
| This is an ASN.1 encoded string representing the pairs of OID/value items supplied in the original SNMP or NVMP trap. | |||
| OBJECT-TYPE | |||
| OCTET STRING | SIZE(0..1500) | ||
| trapLogDescription | 1.3.6.1.4.1.52.4.1.44.3.1.5 | ||
| This is an internally defined string used to describe an alarm. Its primary use is for display on the EMs LCD. A default value will be used for the old trap calls. | |||
| OBJECT-TYPE | |||
| DisplayString | SIZE(0..80) | ||
| timeLogged | 1.3.6.1.4.1.52.4.1.44.3.1.6 | ||
| The time the entry was logged. This will be date and time if possible. | |||
| OBJECT-TYPE | |||
| TimeTicks | |||
| filterId | 1.3.6.1.4.1.52.4.1.44.3.1.7 | ||
| This will be used to filter certain alarms. The criteria is TBD. An example of classification: informational - requires no intervention. warning - Does not require immediate intervention. e.g. static risk severe - Requires immediate intervention. e.g. power overload. fatal - Requires attention and module may take corrective action such as reboot. e.g. Unrecoverable software or hardware error. | |||
| OBJECT-TYPE | |||
| INTEGER | informational(1), warning(2), severe(3), fatal(4), existing(5) | ||
| slotChassis | 1.3.6.1.4.1.52.4.1.44.3.1.8 | ||
| Slot of this trap log. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| trapOID | 1.3.6.1.4.1.52.4.1.44.3.1.9 | ||
| This OID combines the General Trap code, Specific Trap code, and the sys object id into one OID. | |||
| OBJECT-TYPE | |||
| OBJECT IDENTIFIER | |||
| z80Time | 1.3.6.1.4.1.52.4.1.44.3.1.10 | ||
| This is the time that the Z80 has been up for the board that sent this trap. | |||
| OBJECT-TYPE | |||
| TimeTicks | |||
| filterTable | 1.3.6.1.4.1.52.4.1.44.4 | ||
| OBJECT-TYPE | |||
| SEQUENCE OF | |||
| FilterEntry | |||
| filterEntry | 1.3.6.1.4.1.52.4.1.44.4.1 | ||
| Each filter entry is generated from one of the following sources; (1) a module in one of the main chassis slots, (2) the EM, (3) or a power supply. | |||
| OBJECT-TYPE | |||
| FilterEntry | |||
| filterLogId | 1.3.6.1.4.1.52.4.1.44.4.1.1 | ||
| Each slot has a maximum number of log entries that it can support. Each entry is assigned a monotonically increasing sequence number. When the maximum number of entries for a slot is reached, the log wraps. Each new entry willreplace the oldest entry for that slot. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| filterNvmpId | 1.3.6.1.4.1.52.4.1.44.4.1.2 | ||
| This contains the nvmp id of the trap that was generated. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| filterTrapLogAcknowledged | 1.3.6.1.4.1.52.4.1.44.4.1.3 | ||
| This field is non-zero if a trap has been acknowleged from the EM. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| filterTrapLogVarBind | 1.3.6.1.4.1.52.4.1.44.4.1.4 | ||
| This is an ASN.1 encoded string representing the pairs of OID/value items supplied in the original SNMP or NVMP trap. | |||
| OBJECT-TYPE | |||
| OCTET STRING | SIZE(0..1500) | ||
| filterTrapLogDescription | 1.3.6.1.4.1.52.4.1.44.4.1.5 | ||
| This is an internally defined string used to describe an alarm. It's primary use is for display on the EMs LCD. A default value will be used for the old trap calls. | |||
| OBJECT-TYPE | |||
| DisplayString | SIZE(0..80) | ||
| filterTimeLogged | 1.3.6.1.4.1.52.4.1.44.4.1.6 | ||
| The time the entry was logged. This will be date and time if possible. | |||
| OBJECT-TYPE | |||
| TimeTicks | |||
| filterFilterId | 1.3.6.1.4.1.52.4.1.44.4.1.7 | ||
| This will be used tofilter certain alarms. The criteria is TBD. An example of classification: informational-requires no intervention. warning - Does not require immediate intervention. e.g. statis risk severe - Requires immediate intervention. e.g. power overload. fatal - Requires attention and module may take corrective action such as reboot. e.g. Unrecoverale software or hardware error. | |||
| OBJECT-TYPE | |||
| INTEGER | informational(1), warning(2), severe(3), fatal(4), existing(5) | ||
| filterSlotInChassis | 1.3.6.1.4.1.52.4.1.44.4.1.8 | ||
| Slot of this filter entry. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| filterTrapOID | 1.3.6.1.4.1.52.4.1.44.4.1.9 | ||
| This OID combines the General Trap code, Specific Trap code, and the sys object id into one OID. | |||
| OBJECT-TYPE | |||
| OBJECT IDENTIFIER | |||
| filterZ80Time | 1.3.6.1.4.1.52.4.1.44.4.1.10 | ||
| The number of time ticks that have passed since this boards Z80 processor has been up. | |||
| OBJECT-TYPE | |||
| TimeTicks | |||
| trapLoggerAgent | 1.3.6.1.4.1.52.4.1.44.5 | ||
| Reflects the operational status of the traplogger agent | |||
| OBJECT-TYPE | |||
| INTEGER | disabled(1), enabled(2), standby(3), elected(4) | ||
| ConfigTableEntry | |||
| SEQUENCE | |||
| INTEGER as slotInChassis | |||
| Counter as numEntriesLoggeds | |||
| INTEGER as numEntriesRequested | |||
| INTEGER as numEntriesAllocated | |||
| INTEGER as lastLoggedEntryLogId | |||
| INTEGER as logCommand | |||
| INTEGER as wrap | |||
| TrapLogEntry | |||
| SEQUENCE | |||
| INTEGER as logId | |||
| INTEGER as nvmpId | |||
| INTEGER as trapLogAcknowledged | |||
| OCTET STRING as trapLogVarBind | |||
| DisplayString as trapLogDescription | |||
| TimeTicks as timeLogged | |||
| INTEGER as filterId | |||
| INTEGER as slotChassis | |||
| OBJECT IDENTIFIER as trapOID | |||
| TimeTicks as z80Time | |||
| FilterEntry | |||
| SEQUENCE | |||
| INTEGER as filterLogId | |||
| INTEGER as filterNvmpId | |||
| INTEGER as filterTrapLogAcknowledged | |||
| OCTET STRING as filterTrapLogVarBind | |||
| DisplayString as filterTrapLogDescription | |||
| TimeTicks as filterTimeLogged | |||
| INTEGER as filterFilterId | |||
| INTEGER as filterSlotInChassis | |||
| OBJECT IDENTIFIER as filterTrapOID | |||
| TimeTicks as filterZ80Time | |||