
| SNMPv2-SMI | RFC-1215 | RFC1213-MIB |
| RFC-1212 | SNMPv2-CONF | SNMPv2-TC |
| RFC1155-SMI |
| OBJECT-TYPE | TRAP-TYPE | DisplayString |
| OBJECT-TYPE | MODULE-COMPLIANCE | OBJECT-GROUP |
| TEXTUAL-CONVENTION | enterprises |
| sinetica | 1.3.6.1.4.1.3711 | ||
| OBJECT IDENTIFIER | |||
| netcom | 1.3.6.1.4.1.3711.7 | ||
| OBJECT IDENTIFIER | |||
| netcom1 | 1.3.6.1.4.1.3711.7.1 | ||
| OBJECT IDENTIFIER | |||
| netcomObjects | 1.3.6.1.4.1.3711.7.1.1 | ||
| OBJECT IDENTIFIER | |||
| netcomEnvironment | 1.3.6.1.4.1.3711.7.1.1.1 | ||
| OBJECT IDENTIFIER | |||
| netcomEnvHumidity | 1.3.6.1.4.1.3711.7.1.1.1.1 | ||
| OBJECT IDENTIFIER | |||
| netcomEnvHumidityEnableMonitoring | 1.3.6.1.4.1.3711.7.1.1.1.1.1 | ||
| Setting to one enables monitoring of Humidity | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomEnvCurrentHumidity | 1.3.6.1.4.1.3711.7.1.1.1.1.2 | ||
| The current humidity reading in 0.1% | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1000 | ||
| netcomEnvHumidityLowerThreshold | 1.3.6.1.4.1.3711.7.1.1.1.1.3 | ||
| The Lower humidity threshold in 0.1% | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1000 | ||
| netcomEnvHumidityUpperThreshold | 1.3.6.1.4.1.3711.7.1.1.1.1.4 | ||
| The Upper humidity threshold in 0.1% | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1000 | ||
| netcomEnvHumidityCalibrationOffset | 1.3.6.1.4.1.3711.7.1.1.1.1.5 | ||
| Calibration offset in 0.1% | |||
| OBJECT-TYPE | |||
| INTEGER | -100..100 | ||
| netcomLowHumidity | 1.3.6.1.4.1.3711.7.1.1.1.1.21 | ||
| The NetCom-th unit is below the low humidity threshold. | |||
| TRAP-TYPE | |||
| netcomEnvCurrentHumidity | |||
| netcomHighHumidity | 1.3.6.1.4.1.3711.7.1.1.1.1.22 | ||
| The NetCom-th unit is above the high humidity threshold. | |||
| TRAP-TYPE | |||
| netcomEnvCurrentHumidity | |||
| netcomHumidityReturnToNormal | 1.3.6.1.4.1.3711.7.1.1.1.1.23 | ||
| The NetCom-th unit has returned to normal humidity | |||
| TRAP-TYPE | |||
| netcomEnvCurrentHumidity | |||
| netcomEnvTemperature | 1.3.6.1.4.1.3711.7.1.1.1.2 | ||
| OBJECT IDENTIFIER | |||
| netcomEnvTemperatureEnableMonitoring | 1.3.6.1.4.1.3711.7.1.1.1.2.1 | ||
| Setting to one enables monitoring of Temperature | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomEnvCurrentTemperature | 1.3.6.1.4.1.3711.7.1.1.1.2.2 | ||
| The current temperature reading in 0.1% | |||
| OBJECT-TYPE | |||
| INTEGER | -200..1000 | ||
| netcomEnvTemperatureLowerThreshold | 1.3.6.1.4.1.3711.7.1.1.1.2.3 | ||
| The Lower temperature threshold in 0.1 degrees | |||
| OBJECT-TYPE | |||
| INTEGER | -200..1000 | ||
| netcomEnvTemperatureUpperThreshold | 1.3.6.1.4.1.3711.7.1.1.1.2.4 | ||
| The Upper temperature threshold in 0.1 degrees | |||
| OBJECT-TYPE | |||
| INTEGER | -200..1000 | ||
| netcomEnvTemperatureCalibrationOffset | 1.3.6.1.4.1.3711.7.1.1.1.2.5 | ||
| Calibration offset in 0.1 degrees | |||
| OBJECT-TYPE | |||
| INTEGER | -100..100 | ||
| netcomLowTemperature | 1.3.6.1.4.1.3711.7.1.1.1.2.31 | ||
| The NetCom-th unit is below the lower temperature threshold. | |||
| TRAP-TYPE | |||
| netcomEnvCurrentTemperature | |||
| netcomHighTemperature | 1.3.6.1.4.1.3711.7.1.1.1.2.32 | ||
| The NetCom-th unit is above the high temperature threshold. | |||
| TRAP-TYPE | |||
| netcomEnvCurrentTemperature | |||
| netcomTemperatureReturnToNormal | 1.3.6.1.4.1.3711.7.1.1.1.2.33 | ||
| The NetCom-th unit has returned to normal temperature | |||
| TRAP-TYPE | |||
| netcomEnvCurrentTemperature | |||
| netcomContact | 1.3.6.1.4.1.3711.7.1.1.2 | ||
| OBJECT IDENTIFIER | |||
| netcomContactEnable | 1.3.6.1.4.1.3711.7.1.1.2.1 | ||
| Setting to one enables monitoring of contacts | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact1NonNormal | 1.3.6.1.4.1.3711.7.1.1.2.1 | ||
| The NetCom has detected a non-normal state on contact 1 | |||
| TRAP-TYPE | |||
| netcomContactNormalStates | 1.3.6.1.4.1.3711.7.1.1.2.2 | ||
| OBJECT IDENTIFIER | |||
| netcomContact2NonNormal | 1.3.6.1.4.1.3711.7.1.1.2.2 | ||
| The NetCom has detected a non-normal state on contact 2 | |||
| TRAP-TYPE | |||
| netcomContact1NormalState | 1.3.6.1.4.1.3711.7.1.1.2.2.1 | ||
| Set to 0 for normally open condition, 1 for normally closed | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact2NormalState | 1.3.6.1.4.1.3711.7.1.1.2.2.2 | ||
| Set to 0 for normally open condition, 1 for normally closed | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact3NormalState | 1.3.6.1.4.1.3711.7.1.1.2.2.3 | ||
| Set to 0 for normally open condition, 1 for normally closed | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact4NormalState | 1.3.6.1.4.1.3711.7.1.1.2.2.4 | ||
| Set to 0 for normally open condition, 1 for normally closed | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact5NormalState | 1.3.6.1.4.1.3711.7.1.1.2.2.5 | ||
| Set to 0 for normally open condition, 1 for normally closed | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact6NormalState | 1.3.6.1.4.1.3711.7.1.1.2.2.6 | ||
| Set to 0 for normally open condition, 1 for normally closed | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact7NormalState | 1.3.6.1.4.1.3711.7.1.1.2.2.7 | ||
| Set to 0 for normally open condition, 1 for normally closed | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContactCurrentStates | 1.3.6.1.4.1.3711.7.1.1.2.3 | ||
| OBJECT IDENTIFIER | |||
| netcomContact3NonNormal | 1.3.6.1.4.1.3711.7.1.1.2.3 | ||
| The NetCom has detected a non-normal state on contact 3 | |||
| TRAP-TYPE | |||
| netcomContact1CurrentState | 1.3.6.1.4.1.3711.7.1.1.2.3.1 | ||
| The current state of the contact | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact2CurrentState | 1.3.6.1.4.1.3711.7.1.1.2.3.2 | ||
| The current state of the contact | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact3CurrentState | 1.3.6.1.4.1.3711.7.1.1.2.3.3 | ||
| The current state of the contact | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact4CurrentState | 1.3.6.1.4.1.3711.7.1.1.2.3.4 | ||
| The current state of the contact | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact5CurrentState | 1.3.6.1.4.1.3711.7.1.1.2.3.5 | ||
| The current state of the contact | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact6CurrentState | 1.3.6.1.4.1.3711.7.1.1.2.3.6 | ||
| The current state of the contact | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact7CurrentState | 1.3.6.1.4.1.3711.7.1.1.2.3.7 | ||
| The current state of the contact | |||
| OBJECT-TYPE | |||
| INTEGER | 0..1 | ||
| netcomContact4NonNormal | 1.3.6.1.4.1.3711.7.1.1.2.4 | ||
| The NetCom has detected a non-normal state on contact 4 | |||
| TRAP-TYPE | |||
| netcomContact5NonNormal | 1.3.6.1.4.1.3711.7.1.1.2.5 | ||
| The NetCom has detected a non-normal state on contact 5 | |||
| TRAP-TYPE | |||
| netcomContact6NonNormal | 1.3.6.1.4.1.3711.7.1.1.2.6 | ||
| The NetCom has detected a non-normal state on contact 6 | |||
| TRAP-TYPE | |||
| netcomContact7NonNormal | 1.3.6.1.4.1.3711.7.1.1.2.7 | ||
| The NetCom has detected a non-normal state on contact 7 | |||
| TRAP-TYPE | |||
| netcomContact1ReturnToNormal | 1.3.6.1.4.1.3711.7.1.1.2.11 | ||
| The NetCom has detected a return to normal state on contact 1 | |||
| TRAP-TYPE | |||
| netcomContact2ReturnToNormal | 1.3.6.1.4.1.3711.7.1.1.2.12 | ||
| The NetCom has detected a return to normal state on contact 2 | |||
| TRAP-TYPE | |||
| netcomContact3ReturnToNormal | 1.3.6.1.4.1.3711.7.1.1.2.13 | ||
| The NetCom has detected a return to normal state on contact 3 | |||
| TRAP-TYPE | |||
| netcomContact4ReturnToNormal | 1.3.6.1.4.1.3711.7.1.1.2.14 | ||
| The NetCom has detected a return to normal state on contact 4 | |||
| TRAP-TYPE | |||
| netcomContact5ReturnToNormal | 1.3.6.1.4.1.3711.7.1.1.2.15 | ||
| The NetCom has detected a return to normal state on contact 5 | |||
| TRAP-TYPE | |||
| netcomContact6ReturnToNormal | 1.3.6.1.4.1.3711.7.1.1.2.16 | ||
| The NetCom has detected a return to normal state on contact 6 | |||
| TRAP-TYPE | |||
| netcomContact7ReturnToNormal | 1.3.6.1.4.1.3711.7.1.1.2.17 | ||
| The NetCom has detected a return to normal state on contact 7 | |||
| TRAP-TYPE | |||