
| SNMPv2-SMI | SNMPv2-TC | CODAN-SMI |
| MODULE-IDENTITY | OBJECT-TYPE | NOTIFICATION-TYPE |
| Integer32 | TimeTicks | IpAddress |
| Gauge32 | Counter32 | DisplayString |
| DateAndTime | TEXTUAL-CONVENTION | TestAndIncr |
| TimeInterval | TruthValue | satcomMibs |
| rbucMIB | 1.3.6.1.4.1.23304.2.1 | ||
| The Structure of Management Information for the Codan enterprise. Copyright(c) 2009 All rights reserved | |||
| MODULE-IDENTITY | |||
| configuration | 1.3.6.1.4.1.23304.2.1.1 | ||
| OBJECT IDENTIFIER | |||
| txSettings | 1.3.6.1.4.1.23304.2.1.1.1 | ||
| OBJECT IDENTIFIER | |||
| txOn | 1.3.6.1.4.1.23304.2.1.1.1.1 | ||
| Sets Tx on/off. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| txDefault | 1.3.6.1.4.1.23304.2.1.1.1.2 | ||
| Sets Tx default 1-last 0-off. | |||
| OBJECT-TYPE | |||
| TruthValue | |||
| txAttenuator | 1.3.6.1.4.1.23304.2.1.1.1.3 | ||
| Sets/Gets Tx attenuation value in 1dBm steps. | |||
| OBJECT-TYPE | |||
| INTEGER | 0..15 | ||
| pktProtocol | 1.3.6.1.4.1.23304.2.1.1.2 | ||
| OBJECT IDENTIFIER | |||
| protocol | 1.3.6.1.4.1.23304.2.1.1.2.1 | ||
| Sets/Gets packet protocol 0 - ASCII, 1 - CODAN, 2 - . | |||
| OBJECT-TYPE | |||
| INTEGER | 0..4 | ||
| address | 1.3.6.1.4.1.23304.2.1.1.2.2 | ||
| Sets/Gets packet address: 0-31 NDSatcom ... | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| rcSetting | 1.3.6.1.4.1.23304.2.1.1.3 | ||
| OBJECT IDENTIFIER | |||
| mode | 1.3.6.1.4.1.23304.2.1.1.3.1 | ||
| Sets/Gets redundancy mode 0-none, 1-warm, 2-hot. | |||
| OBJECT-TYPE | |||
| INTEGER | 0..2 | ||
| onLine | 1.3.6.1.4.1.23304.2.1.1.3.2 | ||
| Sets/Gets redundancy mode on on/off line state. | |||
| OBJECT-TYPE | |||
| TruthValue | |||
| freqs | 1.3.6.1.4.1.23304.2.1.1.4 | ||
| OBJECT IDENTIFIER | |||
| rfFreq | 1.3.6.1.4.1.23304.2.1.1.4.1 | ||
| Sets/Gets the RBUC RF frequency. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| ifFreq | 1.3.6.1.4.1.23304.2.1.1.4.2 | ||
| Sets/Gets the RBUC IF frequency. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| loFreq | 1.3.6.1.4.1.23304.2.1.1.4.3 | ||
| Sets/Gets the RBUC LO frequency. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| misc | 1.3.6.1.4.1.23304.2.1.1.5 | ||
| OBJECT IDENTIFIER | |||
| serIf | 1.3.6.1.4.1.23304.2.1.1.5.1 | ||
| Sets/Gets serial interface - rate, length, parity, stop, terminate RS422/485. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| serEcho | 1.3.6.1.4.1.23304.2.1.1.5.2 | ||
| Sets/Gets serial interface echo on/off. | |||
| OBJECT-TYPE | |||
| TruthValue | |||
| pwrAlarmThresh | 1.3.6.1.4.1.23304.2.1.1.5.3 | ||
| Sets/Gets power alarm threshold. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| burstPwrThresh | 1.3.6.1.4.1.23304.2.1.1.5.4 | ||
| Sets/Gets burst power threshold. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| refSource | 1.3.6.1.4.1.23304.2.1.1.5.5 | ||
| Sets/Gets reference source 0-external, 1-internal. | |||
| OBJECT-TYPE | |||
| TruthValue | |||
| ledState | 1.3.6.1.4.1.23304.2.1.1.5.6 | ||
| SetS/Gets LEDs status on/off. | |||
| OBJECT-TYPE | |||
| TruthValue | |||
| status | 1.3.6.1.4.1.23304.2.1.2 | ||
| OBJECT IDENTIFIER | |||
| paStatus | 1.3.6.1.4.1.23304.2.1.2.1 | ||
| Gets to 1 when PA is on. | |||
| OBJECT-TYPE | |||
| INTEGER | off(0), on(1) | ||
| txPower | 1.3.6.1.4.1.23304.2.1.2.2 | ||
| Gets Tx power format x.x dB. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| txBurstPower | 1.3.6.1.4.1.23304.2.1.2.3 | ||
| Gets Tx power. Format is x.x,y.y,z.z, where x.x is current burst power, y.y is min and z.z is max burts power. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| faults | 1.3.6.1.4.1.23304.2.1.2.4 | ||
| Gets the current fault status. Format - Bit0 PA fault, Bit1 Fan fault, Bit2 Power fault, Bit3 Temp fault, Bit4 10MHz fault, Bit5 Internal fault Bit6 LNB fault, Bit7 Red'cy Cont fault. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| latchedFaults | 1.3.6.1.4.1.23304.2.1.2.5 | ||
| Gets the current latched faults. Format is same as Faults. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| temperature | 1.3.6.1.4.1.23304.2.1.2.6 | ||
| Gets the BUC temperature. Format is x.x. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| minMaxTemperature | 1.3.6.1.4.1.23304.2.1.2.7 | ||
| Gets the BUC temperature. Format is x.x,y.y where x.x is max and y.y is min temperature. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| systemSetting | 1.3.6.1.4.1.23304.2.1.2.8 | ||
| Gets the current system status. Format is Bit0 - PA state, Bit1 - RS232 Tx, Bit2 - FSK Tx, Bit3 - RS485 Tx Bit4 - Redundancy mode, Bit5 - Online, Bit6..Bit7 - Redundancy cold or hot mode, Bit8 - HTTP Tx, Bit9 - TELNET Tx, Bit10 - SNMP Tx. | |||
| OBJECT-TYPE | |||
| INTEGER | 0..2047 | ||
| systemPoll | 1.3.6.1.4.1.23304.2.1.2.9 | ||
| Gets the system poll status. Format is Bit0 - Fault, Bit1 - System change. | |||
| OBJECT-TYPE | |||
| INTEGER | 0..3 | ||
| deviceType | 1.3.6.1.4.1.23304.2.1.2.10 | ||
| Gets the device type. Format is X,Y where X is the model and Y is software version. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| gateway | 1.3.6.1.4.1.23304.2.1.2.11 | ||
| Gets the BUC gateway address. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| ipAddr | 1.3.6.1.4.1.23304.2.1.2.12 | ||
| Gets the BUC IP address. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| macAddress | 1.3.6.1.4.1.23304.2.1.2.13 | ||
| Gets the BUC MAC address. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| netmask | 1.3.6.1.4.1.23304.2.1.2.14 | ||
| Gets the BUC netmask. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| refPower | 1.3.6.1.4.1.23304.2.1.2.15 | ||
| Gets the BUC reference power. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| bucConfiguration | 1.3.6.1.4.1.23304.2.1.2.16 | ||
| Gets the BUC configuration. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| buildStandard | 1.3.6.1.4.1.23304.2.1.2.17 | ||
| Gets the BUC build standard. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| info | 1.3.6.1.4.1.23304.2.1.3 | ||
| OBJECT IDENTIFIER | |||
| idInfo | 1.3.6.1.4.1.23304.2.1.3.1 | ||
| Gets the module firmware revision, serial number and model. This string will have a zero length if the revision is unknown. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| limits | 1.3.6.1.4.1.23304.2.1.3.2 | ||
| Gets the limit data for the BUC. Format is: Power meter MIN/MAX , IF,RF and LO frequencies. This string will have a zero length if the revision is unknown. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| pktProtocolsInfo | 1.3.6.1.4.1.23304.2.1.3.3 | ||
| Gets supported packet protocols and the corresponding address ranges. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| ComponentRevision | |||
| The hex value in the first octet - xx - represents the major revision no. and the hex value in the second octet - yy - represents the minor revision no. | |||
| TEXTUAL-CONVENTION | |||
| DisplayString | SIZE(2) | ||
| FaultStatus | |||
| Describes all the possible faults in the system as a bit pattern. | |||
| TEXTUAL-CONVENTION | |||
| BITS | pafault(0), lofault(1), internalfault(2), rcfault(3), lnbfault(4) | ||
| TxStatus | |||
| Describes all the possible faults in the system as a bit pattern. | |||
| TEXTUAL-CONVENTION | |||
| BITS | txrs232(0), txrs485(1), txfsk(2), txfsk(3), txsnmp(4), txtelnet(5) | ||