RFC1315-MIB

File: RFC1315-MIB.mib (21845 bytes)

Imported modules

RFC-1212 RFC1213-MIB RFC1155-SMI
RFC-1215

Imported symbols

OBJECT-TYPE transmission Counter
TimeTicks TRAP-TYPE

Defined Objects

frame-relay 1.3.6.1.2.1.10.32
OBJECT IDENTIFIER    

frDlcmiTable 1.3.6.1.2.1.10.32.1
The Parameters for the Data Link Connection Management Interface for the frame relay service on this interface.
OBJECT-TYPE    
  SEQUENCE OF  
    FrDlcmiEntry

frDLCIStatusChange 1.3.6.1.2.1.10.32.1
This trap indicates that the indicated Virtual Circuit has changed state. It has either been created or invalidated, or has toggled between the active and inactive states.
TRAP-TYPE    
  frCircuitIfIndex  
  frCircuitDlci  
  frCircuitState  

frDlcmiEntry 1.3.6.1.2.1.10.32.1.1
The Parameters for a particular Data Link Con- nection Management Interface.
OBJECT-TYPE    
  FrDlcmiEntry  

frDlcmiIfIndex 1.3.6.1.2.1.10.32.1.1.1
The ifIndex value of the corresponding ifEn- try.
OBJECT-TYPE    
  Index  

frDlcmiState 1.3.6.1.2.1.10.32.1.1.2
This variable states which Data Link Connec- tion Management scheme is active (and by impli- cation, what DLCI it uses) on the Frame Relay interface.
OBJECT-TYPE    
  INTEGER noLmiConfigured(1), lmiRev1(2), ansiT1-617-D(3), ansiT1-617-B(4)  

frDlcmiAddress 1.3.6.1.2.1.10.32.1.1.3
This variable states which address format is in use on the Frame Relay interface.
OBJECT-TYPE    
  INTEGER q921(1), q922March90(2), q922November90(3), q922(4)  

frDlcmiAddressLen 1.3.6.1.2.1.10.32.1.1.4
This variable states which address length in octets. In the case of Q922 format, the length indicates the entire length of the address in- cluding the control portion.
OBJECT-TYPE    
  INTEGER two-octets(2), three-octets(3), four-octets(4)  

frDlcmiPollingInterval 1.3.6.1.2.1.10.32.1.1.5
This is the number of seconds between succes- sive status enquiry messages.
OBJECT-TYPE    
  INTEGER 5..30  

frDlcmiFullEnquiryInterval 1.3.6.1.2.1.10.32.1.1.6
Number of status enquiry intervals that pass before issuance of a full status enquiry mes- sage.
OBJECT-TYPE    
  INTEGER 1..255  

frDlcmiErrorThreshold 1.3.6.1.2.1.10.32.1.1.7
This is the maximum number of unanswered Status Enquiries the equipment shall accept be- fore declaring the interface down.
OBJECT-TYPE    
  INTEGER 1..10  

frDlcmiMonitoredEvents 1.3.6.1.2.1.10.32.1.1.8
This is the number of status polling intervals over which the error threshold is counted. For example, if within 'MonitoredEvents' number of events the station receives 'ErrorThreshold' number of errors, the interface is marked as down.
OBJECT-TYPE    
  INTEGER 1..10  

frDlcmiMaxSupportedVCs 1.3.6.1.2.1.10.32.1.1.9
The maximum number of Virtual Circuits allowed for this interface. Usually dictated by the Frame Relay network. In response to a SET, if a value less than zero or higher than the agent's maximal capability is configured, the agent should respond bad- Value
OBJECT-TYPE    
  INTEGER  

frDlcmiMulticast 1.3.6.1.2.1.10.32.1.1.10
This indicates whether the Frame Relay inter- face is using a multicast service.
OBJECT-TYPE    
  INTEGER nonBroadcast(1), broadcast(2)  

frCircuitTable 1.3.6.1.2.1.10.32.2
A table containing information about specific Data Link Connection Identifiers and corresponding virtual circuits.
OBJECT-TYPE    
  SEQUENCE OF  
    FrCircuitEntry

frCircuitEntry 1.3.6.1.2.1.10.32.2.1
The information regarding a single Data Link Connection Identifier.
OBJECT-TYPE    
  FrCircuitEntry  

frCircuitIfIndex 1.3.6.1.2.1.10.32.2.1.1
The ifIndex Value of the ifEntry this virtual circuit is layered onto.
OBJECT-TYPE    
  Index  

frCircuitDlci 1.3.6.1.2.1.10.32.2.1.2
The Data Link Connection Identifier for this virtual circuit.
OBJECT-TYPE    
  DLCI  

frCircuitState 1.3.6.1.2.1.10.32.2.1.3
Indicates whether the particular virtual cir- cuit is operational. In the absence of a Data Link Connection Management Interface, virtual circuit entries (rows) may be created by set- ting virtual circuit state to 'active', or deleted by changing Circuit state to 'invalid'. Whether or not the row actually disappears is left to the implementation, so this object may actually read as 'invalid' for some arbitrary length of time. It is also legal to set the state of a virtual circuit to 'inactive' to temporarily disable a given circuit.
OBJECT-TYPE    
  INTEGER invalid(1), active(2), inactive(3)  

frCircuitReceivedFECNs 1.3.6.1.2.1.10.32.2.1.4
Number of frames received from the network in- dicating forward congestion since the virtual circuit was created.
OBJECT-TYPE    
  Counter  

frCircuitReceivedBECNs 1.3.6.1.2.1.10.32.2.1.5
Number of frames received from the network in- dicating backward congestion since the virtual circuit was created.
OBJECT-TYPE    
  Counter  

frCircuitSentFrames 1.3.6.1.2.1.10.32.2.1.6
The number of frames sent from this virtual circuit since it was created.
OBJECT-TYPE    
  Counter  

frCircuitSentOctets 1.3.6.1.2.1.10.32.2.1.7
The number of octets sent from this virtual circuit since it was created.
OBJECT-TYPE    
  Counter  

frCircuitReceivedFrames 1.3.6.1.2.1.10.32.2.1.8
Number of frames received over this virtual circuit since it was created.
OBJECT-TYPE    
  Counter  

frCircuitReceivedOctets 1.3.6.1.2.1.10.32.2.1.9
Number of octets received over this virtual circuit since it was created.
OBJECT-TYPE    
  Counter  

frCircuitCreationTime 1.3.6.1.2.1.10.32.2.1.10
The value of sysUpTime when the virtual cir- cuit was created, whether by the Data Link Con- nection Management Interface or by a SetRe- quest.
OBJECT-TYPE    
  TimeTicks  

frCircuitLastTimeChange 1.3.6.1.2.1.10.32.2.1.11
The value of sysUpTime when last there was a change in the virtual circuit state
OBJECT-TYPE    
  TimeTicks  

frCircuitCommittedBurst 1.3.6.1.2.1.10.32.2.1.12
This variable indicates the maximum amount of data, in bits, that the network agrees to transfer under normal conditions, during the measurement interval.
OBJECT-TYPE    
  INTEGER  

frCircuitExcessBurst 1.3.6.1.2.1.10.32.2.1.13
This variable indicates the maximum amount of uncommitted data bits that the network will at- tempt to deliver over the measurement interval. By default, if not configured when creating the entry, the Excess Information Burst Size is set to the value of ifSpeed.
OBJECT-TYPE    
  INTEGER  

frCircuitThroughput 1.3.6.1.2.1.10.32.2.1.14
Throughput is the average number of 'Frame Re- lay Information Field' bits transferred per second across a user network interface in one direction, measured over the measurement inter- val. If the configured committed burst rate and throughput are both non-zero, the measurement interval T=frCircuitCommittedBurst/frCircuitThroughput. If the configured committed burst rate and throughput are both zero, the measurement in- terval T=frCircuitExcessBurst/ifSpeed.
OBJECT-TYPE    
  INTEGER  

frErrTable 1.3.6.1.2.1.10.32.3
A table containing information about Errors on the Frame Relay interface.
OBJECT-TYPE    
  SEQUENCE OF  
    FrErrEntry

frErrEntry 1.3.6.1.2.1.10.32.3.1
The error information for a single frame relay interface.
OBJECT-TYPE    
  FrErrEntry  

frErrIfIndex 1.3.6.1.2.1.10.32.3.1.1
The ifIndex Value of the corresponding ifEn- try.
OBJECT-TYPE    
  Index  

frErrType 1.3.6.1.2.1.10.32.3.1.2
The type of error that was last seen on this interface.
OBJECT-TYPE    
  INTEGER unknownError(1), receiveShort(2), receiveLong(3), illegalDLCI(4), unknownDLCI(5), dlcmiProtoErr(6), dlcmiUnknownIE(7), dlcmiSequenceErr(8), dlcmiUnknownRpt(9), noErrorSinceReset(10)  

frErrData 1.3.6.1.2.1.10.32.3.1.3
An octet string containing as much of the er- ror packet as possible. As a minimum, it must contain the Q.922 Address or as much as was delivered. It is desirable to include all in- formation up to the PDU.
OBJECT-TYPE    
  OCTET STRING  

frErrTime 1.3.6.1.2.1.10.32.3.1.4
The value of sysUpTime at which the error was detected.
OBJECT-TYPE    
  TimeTicks  

frame-relay-globals 1.3.6.1.2.1.10.32.4
OBJECT IDENTIFIER    

frTrapState 1.3.6.1.2.1.10.32.4.1
This variable indicates whether the system produces the frDLCIStatusChange trap.
OBJECT-TYPE    
  INTEGER enabled(1), disabled(2)  

Defined Objects

Index  
INTEGER    

DLCI  
INTEGER    

FrDlcmiEntry  
SEQUENCE    
  Index as frDlcmiIfIndex  
  INTEGER as frDlcmiState  
  INTEGER as frDlcmiAddress  
  INTEGER as frDlcmiAddressLen  
  INTEGER as frDlcmiPollingInterval  
  INTEGER as frDlcmiFullEnquiryInterval  
  INTEGER as frDlcmiErrorThreshold  
  INTEGER as frDlcmiMonitoredEvents  
  INTEGER as frDlcmiMaxSupportedVCs  
  INTEGER as frDlcmiMulticast  

FrCircuitEntry  
SEQUENCE    
  Index as frCircuitIfIndex  
  DLCI as frCircuitDlci  
  INTEGER as frCircuitState  
  Counter as frCircuitReceivedFECNs  
  Counter as frCircuitReceivedBECNs  
  Counter as frCircuitSentFrames  
  Counter as frCircuitSentOctets  
  Counter as frCircuitReceivedFrames  
  Counter as frCircuitReceivedOctets  
  TimeTicks as frCircuitCreationTime  
  TimeTicks as frCircuitLastTimeChange  
  INTEGER as frCircuitCommittedBurst  
  INTEGER as frCircuitExcessBurst  
  INTEGER as frCircuitThroughput  

FrErrEntry  
SEQUENCE    
  Index as frErrIfIndex  
  INTEGER as frErrType  
  OCTET STRING as frErrData  
  TimeTicks as frErrTime