RIPv2-MIB

File: RIPv2-MIB.mib (17341 bytes)

Imported modules

SNMPv2-SMI SNMPv2-TC SNMPv2-CONF
RFC1213-MIB

Imported symbols

MODULE-IDENTITY OBJECT-TYPE Counter32
TimeTicks IpAddress TEXTUAL-CONVENTION
RowStatus MODULE-COMPLIANCE OBJECT-GROUP
mib-2

Defined Objects

rip2 1.3.6.1.2.1.23
The MIB module to describe the RIP2 Version 2 Protocol
MODULE-IDENTITY    

rip2Globals 1.3.6.1.2.1.23.1
OBJECT IDENTIFIER    

rip2GlobalRouteChanges 1.3.6.1.2.1.23.1.1
The number of route changes made to the IP Route Database by RIP. This does not include the refresh of a route's age.
OBJECT-TYPE    
  Counter32  

rip2GlobalQueries 1.3.6.1.2.1.23.1.2
The number of responses sent to RIP queries from other systems.
OBJECT-TYPE    
  Counter32  

rip2IfStatTable 1.3.6.1.2.1.23.2
A list of subnets which require separate status monitoring in RIP.
OBJECT-TYPE    
  SEQUENCE OF  
    Rip2IfStatEntry

rip2IfStatEntry 1.3.6.1.2.1.23.2.1
A Single Routing Domain in a single Subnet.
OBJECT-TYPE    
  Rip2IfStatEntry  

rip2IfStatAddress 1.3.6.1.2.1.23.2.1.1
The IP Address of this system on the indicated subnet. For unnumbered interfaces, the value 0.0.0.N, where the least significant 24 bits (N) is the ifIndex for the IP Interface in network byte order.
OBJECT-TYPE    
  IpAddress  

rip2IfStatRcvBadPackets 1.3.6.1.2.1.23.2.1.2
The number of RIP response packets received by the RIP process which were subsequently discarded for any reason (e.g. a version 0 packet, or an unknown command type).
OBJECT-TYPE    
  Counter32  

rip2IfStatRcvBadRoutes 1.3.6.1.2.1.23.2.1.3
The number of routes, in valid RIP packets, which were ignored for any reason (e.g. unknown address family, or invalid metric).
OBJECT-TYPE    
  Counter32  

rip2IfStatSentUpdates 1.3.6.1.2.1.23.2.1.4
The number of triggered RIP updates actually sent on this interface. This explicitly does NOT include full updates sent containing new information.
OBJECT-TYPE    
  Counter32  

rip2IfStatStatus 1.3.6.1.2.1.23.2.1.5
Writing invalid has the effect of deleting this interface.
OBJECT-TYPE    
  RowStatus  

rip2IfConfTable 1.3.6.1.2.1.23.3
A list of subnets which require separate configuration in RIP.
OBJECT-TYPE    
  SEQUENCE OF  
    Rip2IfConfEntry

rip2IfConfEntry 1.3.6.1.2.1.23.3.1
A Single Routing Domain in a single Subnet.
OBJECT-TYPE    
  Rip2IfConfEntry  

rip2IfConfAddress 1.3.6.1.2.1.23.3.1.1
The IP Address of this system on the indicated subnet. For unnumbered interfaces, the value 0.0.0.N, where the least significant 24 bits (N) is the ifIndex for the IP Interface in network byte order.
OBJECT-TYPE    
  IpAddress  

rip2IfConfDomain 1.3.6.1.2.1.23.3.1.2
Value inserted into the Routing Domain field of all RIP packets sent on this interface.
OBJECT-TYPE    
  RouteTag  

rip2IfConfAuthType 1.3.6.1.2.1.23.3.1.3
The type of Authentication used on this interface.
OBJECT-TYPE    
  INTEGER noAuthentication(1), simplePassword(2), md5(3)  

rip2IfConfAuthKey 1.3.6.1.2.1.23.3.1.4
The value to be used as the Authentication Key whenever the corresponding instance of rip2IfConfAuthType has a value other than noAuthentication. A modification of the corresponding instance of rip2IfConfAuthType does not modify the rip2IfConfAuthKey value. If a string shorter than 16 octets is supplied, it will be left- justified and padded to 16 octets, on the right, with nulls (0x00). Reading this object always results in an OCTET STRING of length zero; authentication may not be bypassed by reading the MIB object.
OBJECT-TYPE    
  OCTET STRING SIZE(0..16)  

rip2IfConfSend 1.3.6.1.2.1.23.3.1.5
What the router sends on this interface. ripVersion1 implies sending RIP updates compliant with RFC 1058. rip1Compatible implies broadcasting RIP-2 updates using RFC 1058 route subsumption rules. ripVersion2 implies multicasting RIP-2 updates. ripV1Demand indicates the use of Demand RIP on a WAN interface under RIP Version 1 rules. ripV2Demand indicates the use of Demand RIP on a WAN interface under Version 2 rules.
OBJECT-TYPE    
  INTEGER doNotSend(1), ripVersion1(2), rip1Compatible(3), ripVersion2(4), ripV1Demand(5), ripV2Demand(6)  

rip2IfConfReceive 1.3.6.1.2.1.23.3.1.6
This indicates which version of RIP updates are to be accepted. Note that rip2 and rip1OrRip2 implies reception of multicast packets.
OBJECT-TYPE    
  INTEGER rip1(1), rip2(2), rip1OrRip2(3), doNotRecieve(4)  

rip2IfConfDefaultMetric 1.3.6.1.2.1.23.3.1.7
This variable indicates the metric that is to be used for the default route entry in RIP updates originated on this interface. A value of zero indicates that no default route should be originated; in this case, a default route via another router may be propagated.
OBJECT-TYPE    
  INTEGER 0..15  

rip2IfConfStatus 1.3.6.1.2.1.23.3.1.8
Writing invalid has the effect of deleting this interface.
OBJECT-TYPE    
  RowStatus  

rip2IfConfSrcAddress 1.3.6.1.2.1.23.3.1.9
The IP Address this system will use as a source address on this interface. If it is a numbered interface, this MUST be the same value as rip2IfConfAddress. On unnumbered interfaces, it must be the value of rip2IfConfAddress for some interface on the system.
OBJECT-TYPE    
  IpAddress  

rip2PeerTable 1.3.6.1.2.1.23.4
A list of RIP Peers.
OBJECT-TYPE    
  SEQUENCE OF  
    Rip2PeerEntry

rip2PeerEntry 1.3.6.1.2.1.23.4.1
Information regarding a single routing peer.
OBJECT-TYPE    
  Rip2PeerEntry  

rip2PeerAddress 1.3.6.1.2.1.23.4.1.1
The IP Address that the peer is using as its source address. Note that on an unnumbered link, this may not be a member of any subnet on the system.
OBJECT-TYPE    
  IpAddress  

rip2PeerDomain 1.3.6.1.2.1.23.4.1.2
The value in the Routing Domain field in RIP packets received from the peer. As domain suuport is deprecated, this must be zero.
OBJECT-TYPE    
  RouteTag  

rip2PeerLastUpdate 1.3.6.1.2.1.23.4.1.3
The value of sysUpTime when the most recent RIP update was received from this system.
OBJECT-TYPE    
  TimeTicks  

rip2PeerVersion 1.3.6.1.2.1.23.4.1.4
The RIP version number in the header of the last RIP packet received.
OBJECT-TYPE    
  INTEGER 0..255  

rip2PeerRcvBadPackets 1.3.6.1.2.1.23.4.1.5
The number of RIP response packets from this peer discarded as invalid.
OBJECT-TYPE    
  Counter32  

rip2PeerRcvBadRoutes 1.3.6.1.2.1.23.4.1.6
The number of routes from this peer that were ignored because the entry format was invalid.
OBJECT-TYPE    
  Counter32  

rip2Conformance 1.3.6.1.2.1.23.5
OBJECT IDENTIFIER    

rip2Groups 1.3.6.1.2.1.23.5.1
OBJECT IDENTIFIER    

rip2GlobalGroup 1.3.6.1.2.1.23.5.1.1
This group defines global controls for RIP-II systems.
OBJECT-GROUP    

rip2IfStatGroup 1.3.6.1.2.1.23.5.1.2
This group defines interface statistics for RIP-II systems.
OBJECT-GROUP    

rip2IfConfGroup 1.3.6.1.2.1.23.5.1.3
This group defines interface configuration for RIP-II systems.
OBJECT-GROUP    

rip2PeerGroup 1.3.6.1.2.1.23.5.1.4
This group defines peer information for RIP-II systems.
OBJECT-GROUP    

rip2Compliances 1.3.6.1.2.1.23.5.2
OBJECT IDENTIFIER    

rip2Compliance 1.3.6.1.2.1.23.5.2.1
The compliance statement
MODULE-COMPLIANCE    

Defined Objects

RouteTag  
the RouteTag type represents the contents of the Route Domain field in the packet header or route entry
TEXTUAL-CONVENTION    
  OCTET STRING SIZE(2)  

Rip2IfStatEntry  
SEQUENCE    
  IpAddress as rip2IfStatAddress  
  Counter32 as rip2IfStatRcvBadPackets  
  Counter32 as rip2IfStatRcvBadRoutes  
  Counter32 as rip2IfStatSentUpdates  
  RowStatus as rip2IfStatStatus  

Rip2IfConfEntry  
SEQUENCE    
  IpAddress as rip2IfConfAddress  
  RouteTag as rip2IfConfDomain  
  INTEGER as rip2IfConfAuthType  
  OCTET STRING as rip2IfConfAuthKey SIZE(0..16)  
  INTEGER as rip2IfConfSend  
  INTEGER as rip2IfConfReceive  
  INTEGER as rip2IfConfDefaultMetric  
  RowStatus as rip2IfConfStatus  
  IpAddress as rip2IfConfSrcAddress  

Rip2PeerEntry  
SEQUENCE    
  IpAddress as rip2PeerAddress  
  RouteTag as rip2PeerDomain  
  TimeTicks as rip2PeerLastUpdate  
  INTEGER as rip2PeerVersion  
  Counter32 as rip2PeerRcvBadPackets  
  Counter32 as rip2PeerRcvBadRoutes