EXTREME-SNMPV3-MIB

File: EXTREME-SNMPV3-MIB.mib (4667 bytes)

Imported modules

SNMPv2-SMI SNMPv2-TC EXTREME-BASE-MIB
SNMP-TARGET-MIB

Imported symbols

MODULE-IDENTITY OBJECT-TYPE TruthValue
extremeAgent snmpTargetAddrEntry

Defined Objects

extremeSnmpv3 1.3.6.1.4.1.1916.1.23
Extreme-specific SNMPv3 objects
MODULE-IDENTITY    

extremeTarget 1.3.6.1.4.1.1916.1.23.1
OBJECT IDENTIFIER    

extremeTargetAddrExtTable 1.3.6.1.4.1.1916.1.23.1.1
This table is an extension to the snmpTargetAddrTable found in the SNMP-TARGET-MIB. It contains Extreme Networks specific objects needed for each management target.
OBJECT-TYPE    
  SEQUENCE OF  
    ExtremeTargetAddrExtEntry

extremeTargetAddrExtEntry 1.3.6.1.4.1.1916.1.23.1.1.1
An entry in the extremeTargetAddrExtTable.
OBJECT-TYPE    
  ExtremeTargetAddrExtEntry  

extremeTargetAddrExtIgnoreMPModel 1.3.6.1.4.1.1916.1.23.1.1.1.1
When this object is set to TRUE, the version of the trap/notification sent to the corresponding management target (trap receiver) will be the same as in releases of Extremeware prior to 7.1.0. Thus, the value of the snmpTargetParamsMPModel object in the snmpTargetParamsTable will be ignored while determining the version of the trap/notification to be sent. When a trap-receiver is created via the RMON trapDestTable or from the CLI command 'configure snmp add trapreceiver ....', the value of this object will be set to TRUE for the corresponding entry in this table.
OBJECT-TYPE    
  TruthValue  

extremeTargetAddrExtStandardMode 1.3.6.1.4.1.1916.1.23.1.1.1.2
When this object is set to TRUE, the management target will be treated as a 'standard mode' one, in that any Extreme Networks specific extra varbinds present in a standards-based trap/notification will not be sent to this management target. Only the varbinds defined in the standard will be sent.
OBJECT-TYPE    
  TruthValue  

extremeTargetAddrExtTrapDestIndex 1.3.6.1.4.1.1916.1.23.1.1.1.3
This object contains the value of the trapDestIndex in the corresponding entry of the RMON trapDestTable.
OBJECT-TYPE    
  INTEGER  

extremeTargetAddrExtUseEventComm 1.3.6.1.4.1.1916.1.23.1.1.1.4
This object is used only when sending RMON alarms as SNMPv3 traps. When it is set to TRUE and an RMON risingAlarm or fallingAlarm is being sent for an event, then the eventCommunity in the RMON event table is compared to the snmpTargetAddrName in the snmpTargetAddrTable. The alarm is sent to the target only when the two are the same. This behavior is exhibited only when the snmpTargetParamsMPModel corresponding to the target indicates an SNMPv3 trap. For SNMPv1/v2c traps, the community in the RMON trapDestTable is used for the comparision, which is the 'regular' method, as per the standards. When this object is set to FALSE, then the RMON alarm (if being sent as an SNMPv3 trap) is sent without using the event community for any comparision.
OBJECT-TYPE    
  TruthValue  

Defined Objects

ExtremeTargetAddrExtEntry  
SEQUENCE    
  TruthValue as extremeTargetAddrExtIgnoreMPModel  
  TruthValue as extremeTargetAddrExtStandardMode  
  INTEGER as extremeTargetAddrExtTrapDestIndex  
  TruthValue as extremeTargetAddrExtUseEventComm