OSPF-TRAP-MIB

File: OSPF-TRAP-MIB.mib (16824 bytes)

Imported modules

SNMPv2-SMI SNMPv2-CONF OSPF-MIB

Imported symbols

MODULE-IDENTITY OBJECT-TYPE NOTIFICATION-TYPE
IpAddress MODULE-COMPLIANCE OBJECT-GROUP
ospfRouterId ospfIfIpAddress ospfAddressLessIf
ospfIfState ospfVirtIfAreaId ospfVirtIfNeighbor
ospfVirtIfState ospfNbrIpAddr ospfNbrAddressLessIndex
ospfNbrRtrId ospfNbrState ospfVirtNbrArea
ospfVirtNbrRtrId ospfVirtNbrState ospfLsdbType
ospfLsdbLsid ospfLsdbRouterId ospfLsdbAreaId
ospfExtLsdbLimit ospf

Defined Objects

ospfTrap 1.3.6.1.2.1.14.16
The MIB module to describe traps for the OSPF Version 2 Protocol.
MODULE-IDENTITY    

ospfTrapControl 1.3.6.1.2.1.14.16.1
OBJECT IDENTIFIER    

ospfSetTrap 1.3.6.1.2.1.14.16.1.1
A four-octet string serving as a bit map for the trap events defined by the OSPF traps. This object is used to enable and disable specific OSPF traps where a 1 in the bit field represents enabled. The right-most bit (least significant) represents trap 0.
OBJECT-TYPE    
  OCTET STRING SIZE(4)  

ospfConfigErrorType 1.3.6.1.2.1.14.16.1.2
Potential types of configuration conflicts. Used by the ospfConfigError and ospfConfigVir- tError traps.
OBJECT-TYPE    
  INTEGER badVersion(1), areaMismatch(2), unknownNbmaNbr(3), unknownVirtualNbr(4), authTypeMismatch(5), authFailure(6), netMaskMismatch(7), helloIntervalMismatch(8), deadIntervalMismatch(9), optionMismatch(10)  

ospfPacketType 1.3.6.1.2.1.14.16.1.3
OSPF packet types.
OBJECT-TYPE    
  INTEGER hello(1), dbDescript(2), lsReq(3), lsUpdate(4), lsAck(5)  

ospfPacketSrc 1.3.6.1.2.1.14.16.1.4
The IP address of an inbound packet that can- not be identified by a neighbor instance.
OBJECT-TYPE    
  IpAddress  

ospfTraps 1.3.6.1.2.1.14.16.2
OBJECT IDENTIFIER    

ospfVirtIfStateChange 1.3.6.1.2.1.14.16.2.1
An ospfIfStateChange trap signifies that there has been a change in the state of an OSPF vir- tual interface. This trap should be generated when the inter- face state regresses (e.g., goes from Point- to-Point to Down) or progresses to a terminal state (i.e., Point-to-Point).
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfVirtIfAreaId  
  ospfVirtIfNeighbor  
  ospfVirtIfState  

ospfNbrStateChange 1.3.6.1.2.1.14.16.2.2
An ospfNbrStateChange trap signifies that there has been a change in the state of a non- virtual OSPF neighbor. This trap should be generated when the neighbor state regresses (e.g., goes from Attempt or Full to 1-Way or Down) or progresses to a terminal state (e.g., 2-Way or Full). When an neighbor transitions from or to Full on non-broadcast multi-access and broadcast networks, the trap should be gen- erated by the designated router. A designated router transitioning to Down will be noted by ospfIfStateChange.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfNbrIpAddr  
  ospfNbrAddressLessIndex  
  ospfNbrRtrId  
  ospfNbrState  

ospfVirtNbrStateChange 1.3.6.1.2.1.14.16.2.3
An ospfIfStateChange trap signifies that there has been a change in the state of an OSPF vir- tual neighbor. This trap should be generated when the neighbor state regresses (e.g., goes from Attempt or Full to 1-Way or Down) or progresses to a terminal state (e.g., Full).
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfVirtNbrArea  
  ospfVirtNbrRtrId  
  ospfVirtNbrState  

ospfIfConfigError 1.3.6.1.2.1.14.16.2.4
An ospfIfConfigError trap signifies that a packet has been received on a non-virtual in- terface from a router whose configuration parameters conflict with this router's confi- guration parameters. Note that the event op- tionMismatch should cause a trap only if it prevents an adjacency from forming.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfIfIpAddress  
  ospfAddressLessIf  
  ospfPacketSrc  
  ospfConfigErrorType  
  ospfPacketType  

ospfVirtIfConfigError 1.3.6.1.2.1.14.16.2.5
An ospfConfigError trap signifies that a pack- et has been received on a virtual interface from a router whose configuration parameters conflict with this router's configuration parameters. Note that the event optionMismatch should cause a trap only if it prevents an ad- jacency from forming.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfVirtIfAreaId  
  ospfVirtIfNeighbor  
  ospfConfigErrorType  
  ospfPacketType  

ospfIfAuthFailure 1.3.6.1.2.1.14.16.2.6
An ospfIfAuthFailure trap signifies that a packet has been received on a non-virtual in- terface from a router whose authentication key or authentication type conflicts with this router's authentication key or authentication type.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfIfIpAddress  
  ospfAddressLessIf  
  ospfPacketSrc  
  ospfConfigErrorType  
  ospfPacketType  

ospfVirtIfAuthFailure 1.3.6.1.2.1.14.16.2.7
An ospfVirtIfAuthFailure trap signifies that a packet has been received on a virtual interface from a router whose authentication key or au- thentication type conflicts with this router's authentication key or authentication type.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfVirtIfAreaId  
  ospfVirtIfNeighbor  
  ospfConfigErrorType  
  ospfPacketType  

ospfIfRxBadPacket 1.3.6.1.2.1.14.16.2.8
An ospfIfRxBadPacket trap signifies that an OSPF packet has been received on a non-virtual interface that cannot be parsed.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfIfIpAddress  
  ospfAddressLessIf  
  ospfPacketSrc  
  ospfPacketType  

ospfVirtIfRxBadPacket 1.3.6.1.2.1.14.16.2.9
An ospfRxBadPacket trap signifies that an OSPF packet has been received on a virtual interface that cannot be parsed.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfVirtIfAreaId  
  ospfVirtIfNeighbor  
  ospfPacketType  

ospfTxRetransmit 1.3.6.1.2.1.14.16.2.10
An ospfTxRetransmit trap signifies than an OSPF packet has been retransmitted on a non- virtual interface. All packets that may be re- transmitted are associated with an LSDB entry. The LS type, LS ID, and Router ID are used to identify the LSDB entry.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfIfIpAddress  
  ospfAddressLessIf  
  ospfNbrRtrId  
  ospfPacketType  
  ospfLsdbType  
  ospfLsdbLsid  
  ospfLsdbRouterId  

ospfVirtIfTxRetransmit 1.3.6.1.2.1.14.16.2.11
An ospfTxRetransmit trap signifies than an OSPF packet has been retransmitted on a virtual interface. All packets that may be retransmit- ted are associated with an LSDB entry. The LS type, LS ID, and Router ID are used to identify the LSDB entry.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfVirtIfAreaId  
  ospfVirtIfNeighbor  
  ospfPacketType  
  ospfLsdbType  
  ospfLsdbLsid  
  ospfLsdbRouterId  

ospfOriginateLsa 1.3.6.1.2.1.14.16.2.12
An ospfOriginateLsa trap signifies that a new LSA has been originated by this router. This trap should not be invoked for simple refreshes of LSAs (which happesn every 30 minutes), but instead will only be invoked when an LSA is (re)originated due to a topology change. Addi- tionally, this trap does not include LSAs that are being flushed because they have reached MaxAge.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfLsdbAreaId  
  ospfLsdbType  
  ospfLsdbLsid  
  ospfLsdbRouterId  

ospfMaxAgeLsa 1.3.6.1.2.1.14.16.2.13
An ospfMaxAgeLsa trap signifies that one of the LSA in the router's link-state database has aged to MaxAge.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfLsdbAreaId  
  ospfLsdbType  
  ospfLsdbLsid  
  ospfLsdbRouterId  

ospfLsdbOverflow 1.3.6.1.2.1.14.16.2.14
An ospfLsdbOverflow trap signifies that the number of LSAs in the router's link-state data- base has exceeded ospfExtLsdbLimit.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfExtLsdbLimit  

ospfLsdbApproachingOverflow 1.3.6.1.2.1.14.16.2.15
An ospfLsdbApproachingOverflow trap signifies that the number of LSAs in the router's link- state database has exceeded ninety percent of ospfExtLsdbLimit.
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfExtLsdbLimit  

ospfIfStateChange 1.3.6.1.2.1.14.16.2.16
An ospfIfStateChange trap signifies that there has been a change in the state of a non-virtual OSPF interface. This trap should be generated when the interface state regresses (e.g., goes from Dr to Down) or progresses to a terminal state (i.e., Point-to-Point, DR Other, Dr, or Backup).
NOTIFICATION-TYPE    
  ospfRouterId  
  ospfIfIpAddress  
  ospfAddressLessIf  
  ospfIfState  

ospfTrapConformance 1.3.6.1.2.1.14.16.3
OBJECT IDENTIFIER    

ospfTrapGroups 1.3.6.1.2.1.14.16.3.1
OBJECT IDENTIFIER    

ospfTrapControlGroup 1.3.6.1.2.1.14.16.3.1.1
These objects are required to control traps from OSPF systems.
OBJECT-GROUP    

ospfTrapCompliances 1.3.6.1.2.1.14.16.3.2
OBJECT IDENTIFIER    

ospfTrapCompliance 1.3.6.1.2.1.14.16.3.2.1
The compliance statement
MODULE-COMPLIANCE