
| RFC1155-SMI | RFC1213-MIB | RFC-1212 |
| PANDATEL-MODEM-MIB |
| enterprises | Gauge | DisplayString |
| OBJECT-TYPE | mdmSpecifics | device-id |
| fhflf | 1.3.6.1.4.1.760.1.1.2.1.10.102 | ||
| OBJECT IDENTIFIER | |||
| fhflfModemTable | 1.3.6.1.4.1.760.1.1.2.1.10.102.1 | ||
| This table contains information about all FH/FL-F modems in all racks. | |||
| OBJECT-TYPE | |||
| SEQUENCE OF | |||
| FhflfTableEntry | |||
| fhflfTableEntry | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1 | ||
| The index of the table. | |||
| OBJECT-TYPE | |||
| FhflfTableEntry | |||
| mdmRack | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.1 | ||
| The index of the rack where the modem is installed. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| mdmModem | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.2 | ||
| This entry displays the slot number where the corresponding modem is installed in the rack. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| mdmPosition | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.3 | ||
| This entry displays the location of the corresponding modem: 'local' or 'remote'. The modem which is plugged into a managed rack is 'local', the counterpart is 'remote'. | |||
| OBJECT-TYPE | |||
| INTEGER | local(1), remote(2) | ||
| mdmModemName | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.5 | ||
| The verbal name of this modem. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| mdmInterfaceEmulationMode | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.6 | ||
| Interface mode of the unit: 'dte', 'dce', 'te' or 'nt'. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), dte(2), dce(3), te(4), nt(5), unknown(99) | ||
| mdmModemProperty | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.7 | ||
| This entry displays the speed class of the FH/FL-F: 'e1' or 't1'. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), e1(2), t1(3), unknown(99) | ||
| mdmClockSystem | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.23 | ||
| The clock system of the link: 'dual' or 'single'. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), dual(2), single(3) | ||
| mdmClockSource | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.24 | ||
| The clock source of the link: 'internal', 'external', or 'remote'. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), internal(2), remote(3), external(4) | ||
| mdmDataRate | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.25 | ||
| The data rate at the interface in bits per seconds. The data rate at the remote counterpart changes simultaneously. A data rate of 2.048 Mbps (E1) automatically disables CRC4, sets mdmStartTimeslot to 'unframed', enables time slot 16. A data rate of 1.984 Mbps (E1) automatically sets mdmStartTimeslot to 'timeslot-1', enables time slot 16. A data rate of 1.544 Mbps (T1) automatically sets mdmStartTimeslot to 'unframed'. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1) | ||
| mdmStartTimeslot | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.26 | ||
| This entry determines the start time slot for framing. Start time slot and data rate must match. A start time slot which is too high will be ignored. The remote unit's configuration changes simultaneously. | |||
| OBJECT-TYPE | |||
| INTEGER | timeslot-1(1), timeslot-2(2), timeslot-3(3), timeslot-4(4), timeslot-5(5), timeslot-6(6), timeslot-7(7), timeslot-8(8), timeslot-9(9), timeslot-10(10), timeslot-11(11), timeslot-12(12), timeslot-13(13), timeslot-14(14), timeslot-15(15), timeslot-16(16), timeslot-17(17), timeslot-18(18), timeslot-19(19), timeslot-20(20), timeslot-21(21), timeslot-22(22), timeslot-23(23), timeslot-24(24), timeslot-25(25), timeslot-26(26), timeslot-27(27), timeslot-28(28), timeslot-29(29), timeslot-30(30), timeslot-31(31), unframed(98), other(99), not-available(100) | ||
| mdmTimeslotSize | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.27 | ||
| This entry determines the size of the time slots: 'nx64k' or 'nx56k'. 'nx56k' is valid for T1 units only. The remote unit's configuration changes simultaneously. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), nx64k(2), nx56k(3), not-available(100) | ||
| mdmTimeslot16 | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.40 | ||
| This entry enables or disables time slot 16. If it is disabled, it will not be used for data transmission but for framing. Valid for E1 units only. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), disable(2), enable(3), not-available(100) | ||
| mdmCRC4Generation | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.41 | ||
| This entry enables or disables the generation of a CRC4 check sum. The remote unit's configuration changes simultaneously. Valid for E1 units only. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), disable(2), enable(3), not-available(100) | ||
| mdmFramingMode | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.50 | ||
| The T1 framing mode: 'd4' or 'esf'. The remote unit's configuration changes simultaneously. Valid for T1 units only. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), d4(2), esf(3), not-available(100) | ||
| mdmLocalCarrierDetect | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.60 | ||
| The data carrier detect mode at the interface: if set to 'fo-link-and-remote-handshake' the DCD signal (resp. I for X.21, etc.) follows link status and remote RTS (resp. C for X.21, etc.), if set to 'fo-link' the DCD signal follows link status only. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), fo-link-and-remote-handshake(2), fo-link(3) | ||
| mdmFOPower | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.71 | ||
| The fiber optic transmit power at the line port | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), low(2), high(3), unknown(99) | ||
| mdmCRC6Test | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.100 | ||
| This entry enables the execution of a CRC6 test. Write requests with values other than 'start' or 'stop' will be rejected. Valid for T1 units only. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), start(3), stop(4), not-available(100) | ||
| mdmCRC6Status | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.101 | ||
| This entry indicates the status of the CRC6 test. Valid for T1 units only. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), never-started(2), running(5), stopped(6), start-failed(7), not-available(100) | ||
| mdmCRC6Error | 1.3.6.1.4.1.760.1.1.2.1.10.102.1.1.102 | ||
| This entry indicates the number of errors detected during the last 60 seconds. | |||
| OBJECT-TYPE | |||
| Gauge | |||
| fhflf-modem | 1.3.6.1.4.1.760.1.1.2.1.10.10000.2.102 | ||
| OBJECT IDENTIFIER | |||
| FhflfTableEntry | |||
| SEQUENCE | |||
| INTEGER as mdmRack | |||
| INTEGER as mdmModem | |||
| INTEGER as mdmPosition | |||
| DisplayString as mdmModemName | |||
| INTEGER as mdmInterfaceEmulationMode | |||
| INTEGER as mdmModemProperty | |||
| INTEGER as mdmClockSystem | |||
| INTEGER as mdmClockSource | |||
| INTEGER as mdmDataRate | |||
| INTEGER as mdmStartTimeslot | |||
| INTEGER as mdmTimeslotSize | |||
| INTEGER as mdmTimeslot16 | |||
| INTEGER as mdmCRC4Generation | |||
| INTEGER as mdmFramingMode | |||
| INTEGER as mdmLocalCarrierDetect | |||
| INTEGER as mdmFOPower | |||
| INTEGER as mdmCRC6Test | |||
| INTEGER as mdmCRC6Status | |||
| Gauge as mdmCRC6Error | |||