
| RFC1155-SMI | RFC1213-MIB | RFC-1212 |
| PANDATEL-MODEM-MIB |
| enterprises | DisplayString | OBJECT-TYPE |
| mdmSpecifics | device-id |
| fxg | 1.3.6.1.4.1.760.1.1.2.1.10.506 | ||
| OBJECT IDENTIFIER | |||
| fxgModemTable | 1.3.6.1.4.1.760.1.1.2.1.10.506.1 | ||
| The table of all FX-G modems in this housing. | |||
| OBJECT-TYPE | |||
| SEQUENCE OF | |||
| FxgTableEntry | |||
| fxgTableEntry | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1 | ||
| The index of the table. | |||
| OBJECT-TYPE | |||
| FxgTableEntry | |||
| mdmRack | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.1 | ||
| The index of the rack where the modem is installed. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| mdmModem | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.2 | ||
| This variable displays the slot number where the corresponding modem is installed in the rack. | |||
| OBJECT-TYPE | |||
| INTEGER | |||
| mdmPosition | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.3 | ||
| This variable displays the location of the corresponding modem: 'local' or 'remote'. The modem which is plugged into a managed rack is 'local', the counterpart is 'remote'. | |||
| OBJECT-TYPE | |||
| INTEGER | local(1), remote(2) | ||
| mdmModemName | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.5 | ||
| A verbal name of this modem. | |||
| OBJECT-TYPE | |||
| DisplayString | |||
| mdmAlarm | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.15 | ||
| The status of local alarm: 'off' or 'on'. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), off(2), on(3) | ||
| mdmRemoteAccessMode | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.64 | ||
| The possibility of remote management: 'enabled', 'disabled local' or 'disable local and remote'. Once disabled management at local and remote unit, it is not possible to enable it at the remote unit again. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), enable(5), disable-local(8), disable-local-and-remote(9) | ||
| mdmForcedRemoteAccess | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.65 | ||
| Activation of remote management: 'on' or 'off'. Status 'on' enables management of remote unit. During this process the link is restricted to management data. The transmission of user data is interrupted. Status 'off' disables management of remote unit. The link transmits user data. | |||
| OBJECT-TYPE | |||
| INTEGER | off(1), on(2) | ||
| mdmClockRecovery | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.70 | ||
| The clock recovery and data retiming at interface and line port. The remote unit's configuration changes simultaneously. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), disable(2), gigabit-Ethernet-1250(6), fibre-Channel-1062(7), not-available(100) | ||
| mdmOperationMode | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.72 | ||
| The possibility of operation mode: 'converter mode' or 'modem mode'. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), modem-mode(2), converter-mode(3) | ||
| mdmInterfaceAlarmCondition | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.98 | ||
| The alarm trigger mode at interface port: 'disable', i.e. no alarm is triggered, 'no-link-signal', i.e. an alarm is triggered if the link is down. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), disable(2), no-link-signal(3), not-available(100) | ||
| mdmLineAlarmCondition | 1.3.6.1.4.1.760.1.1.2.1.10.506.1.1.99 | ||
| The alarm trigger mode at line port: 'disable', i.e. no alarm is triggered, 'no-link-signal', i.e. an alarm is triggered if the link is down. | |||
| OBJECT-TYPE | |||
| INTEGER | other(1), disable(2), no-link-signal(3), not-available(100) | ||
| fxg-modem | 1.3.6.1.4.1.760.1.1.2.1.10.10000.2.506 | ||
| OBJECT IDENTIFIER | |||
| FxgTableEntry | |||
| SEQUENCE | |||
| INTEGER as mdmRack | |||
| INTEGER as mdmModem | |||
| INTEGER as mdmPosition | |||
| DisplayString as mdmModemName | |||
| INTEGER as mdmAlarm | |||
| INTEGER as mdmRemoteAccessMode | |||
| INTEGER as mdmForcedRemoteAccess | |||
| INTEGER as mdmClockRecovery | |||
| INTEGER as mdmOperationMode | |||
| INTEGER as mdmInterfaceAlarmCondition | |||
| INTEGER as mdmLineAlarmCondition | |||