PANDATEL-GMD-MODEM-MIB

File: PANDATEL-GMD-MODEM-MIB.mib (12382 bytes)

Imported modules

RFC1155-SMI RFC1213-MIB RFC-1212
PANDATEL-MODEM-MIB

Imported symbols

enterprises Gauge DisplayString
OBJECT-TYPE mdmSpecifics device-id

Defined Objects

gmd 1.3.6.1.4.1.760.1.1.2.1.10.203
OBJECT IDENTIFIER    

gmdModemTable 1.3.6.1.4.1.760.1.1.2.1.10.203.1
This table contains information about all GM-D modems in all racks.
OBJECT-TYPE    
  SEQUENCE OF  
    GmdTableEntry

gmdTableEntry 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1
The index of the table.
OBJECT-TYPE    
  GmdTableEntry  

mdmRack 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.1
The index of the rack where the modem is installed.
OBJECT-TYPE    
  INTEGER  

mdmModem 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.2
This entry displays the slot number where the corresponding modem is installed in the rack.
OBJECT-TYPE    
  INTEGER  

mdmPosition 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.3
This entry displays the location of the corresponding modem: 'local' or 'remote'. The modem which is plugged into a managed rack is 'local', the counterpart is 'remote'.
OBJECT-TYPE    
  INTEGER local(1), remote(2)  

mdmModemName 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.5
The verbal name of this modem.
OBJECT-TYPE    
  DisplayString  

mdmDataEquipmentEmulation 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.6
Interface mode of the unit: 'dte' or 'dce'.
OBJECT-TYPE    
  INTEGER other(1), dte(2), dce(3), unknown(99)  

mdmModemProperty 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.7
This entry displays the speed class of the GM-D: 'e1'.
OBJECT-TYPE    
  INTEGER other(1), e1(2), t1(3), unknown(99)  

mdmHDSLUnit 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.10
HDSL unit type: Line Termination Unit ('LTU') or Network Termination Unit ('NTU')
OBJECT-TYPE    
  INTEGER other(1), ntu(2), ltu(3)  

mdmClockSystem 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.23
The clock system of the link: 'dual' or 'single'.
OBJECT-TYPE    
  INTEGER other(1), dual(2), single(3)  

mdmClockSource 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.24
The clock source of the link: 'internal', 'external', or 'remote'.
OBJECT-TYPE    
  INTEGER other(1), internal(2), remote(3), external(4)  

mdmDataRate 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.25
The data rate at the interface in bits per seconds. The data rate at the remote counterpart changes simultaneously. A data rate of 2.048 Mbps (E1) automatically disables CRC4, sets mdmStartChannel to 'unframed' and enables time slot 16. A data rate of 1.984 Mbps (E1) automatically sets mdmStartChannel to 'channel-1' and enables time slot 16.
OBJECT-TYPE    
  INTEGER other(1)  

mdmStartChannel 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.26
This entry determines the start channel for framing. Start channel and data rate must match. A start channel which is too high will be ignored. The remote unit's configuration changes simultaneously.
OBJECT-TYPE    
  INTEGER channel-1(1), channel-2(2), channel-3(3), channel-4(4), channel-5(5), channel-6(6), channel-7(7), channel-8(8), channel-9(9), channel-10(10), channel-11(11), channel-12(12), channel-13(13), channel-14(14), channel-15(15), channel-16(16), channel-17(17), channel-18(18), channel-19(19), channel-20(20), channel-21(21), channel-22(22), channel-23(23), channel-24(24), channel-25(25), channel-26(26), channel-27(27), channel-28(28), channel-29(29), channel-30(30), channel-31(31), unframed(98), other(99), not-available(100)  

mdmTimeslot16 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.40
This entry enables or disables time slot 16. If it is disabled, it will not be used for data transmission but for framing.
OBJECT-TYPE    
  INTEGER other(1), disable(2), enable(3), not-available(100)  

mdmCRC4Generation 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.41
This entry enables or disables the generation of a CRC4 check sum.
OBJECT-TYPE    
  INTEGER other(1), disable(2), enable(3)  

mdmHDSLFramer 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.62
This entry enables or disables HDSL framing. The remote unit's configuration changes simultaneously.
OBJECT-TYPE    
  INTEGER other(1), disable(2), enable(3)  

mdmCRC6Test 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.100
This entry enables the execution of a CRC6 test. Write requests with values other than 'start' or 'stop' will be rejected.
OBJECT-TYPE    
  INTEGER other(1), start(3), stop(4), not-available(100)  

mdmPair1CRC6Status 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.101
This entry indicates the status of the CRC6 test at pair 1.
OBJECT-TYPE    
  INTEGER other(1), never-started(2), running(5), stopped(6), start-failed(7), not-available(100)  

mdmPair1CRC6Error 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.102
This entry indicates the number of errors detected during the last 60 seconds at pair 1.
OBJECT-TYPE    
  Gauge  

mdmPair2CRC6Status 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.103
This entry indicates the status of the CRC6 test at pair 2.
OBJECT-TYPE    
  INTEGER other(1), never-started(2), running(5), stopped(6), start-failed(7), not-available(100)  

mdmPair2CRC6Error 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.104
This entry indicates the number of errors detected during the last 60 seconds at pair 2.
OBJECT-TYPE    
  Gauge  

mdmPair3CRC6Status 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.105
This entry indicates the status of the CRC6 test at pair 3.
OBJECT-TYPE    
  INTEGER other(1), never-started(2), running(5), stopped(6), start-failed(7), not-available(100)  

mdmPair3CRC6Error 1.3.6.1.4.1.760.1.1.2.1.10.203.1.1.106
This entry indicates the number of errors detected during the last 60 seconds at pair 3.
OBJECT-TYPE    
  Gauge  

gmd-modem 1.3.6.1.4.1.760.1.1.2.1.10.10000.2.203
OBJECT IDENTIFIER    

Defined Objects

GmdTableEntry  
SEQUENCE    
  INTEGER as mdmRack  
  INTEGER as mdmModem  
  INTEGER as mdmPosition  
  DisplayString as mdmModemName  
  INTEGER as mdmDataEquipmentEmulation  
  INTEGER as mdmModemProperty  
  INTEGER as mdmHDSLUnit  
  INTEGER as mdmClockSystem  
  INTEGER as mdmClockSource  
  INTEGER as mdmDataRate  
  INTEGER as mdmStartChannel  
  INTEGER as mdmTimeslot16  
  INTEGER as mdmCRC4Generation  
  INTEGER as mdmHDSLFramer  
  INTEGER as mdmCRC6Test  
  INTEGER as mdmPair1CRC6Status  
  Gauge as mdmPair1CRC6Error  
  INTEGER as mdmPair2CRC6Status  
  Gauge as mdmPair2CRC6Error  
  INTEGER as mdmPair3CRC6Status  
  Gauge as mdmPair3CRC6Error